| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| What's your set up? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=31519 |
Page 1 of 1 |
| Author: | 501 [ Sun Apr 13, 2008 11:08 pm ] |
| Post subject: | What's your set up? |
What are you running on your KJ and what kind of issues (if any) are you having with your setup? Rim Brand? Rim Size? Backspacing? Offset? Tire Brand? Tire Size? Tire type? Issues (problems) with the setup? |
|
| Author: | tjkj2002 [ Sun Apr 13, 2008 11:16 pm ] |
| Post subject: | |
Rim Brand? -----Unique Steel series 297 Rim Size? -----16x7 Backspacing? -----4.5" Offset? -----zero Tire Brand? -----Interco Trxus MT's Tire Size? -----265/75R16 Tire type? -----MT Issues (problems) with the setup? -----Need over 3" of lift,major trimming F/R bumbers(stock plastic),pound down pinchwelds a must,trimming rear flares a must for full flex,need 4.10 gears at a min,stop being stupid with the skinny pedal,and extended bumpstops a must.Having aftermarket F/R bumbers help with clearence issues. The biggest problem is the need to go bigger and that cost big $$$$ to do(SFA). |
|
| Author: | cmohr [ Mon Apr 14, 2008 1:08 am ] |
| Post subject: | |
Rim Brand? -----------King Rim Size? -------------15 x 7 Backspacing? --------3.5in Offset? ---------------zero Tire Brand? ----------Mickey Thompson MTZ Tire Size? ------------31/10.5/15 Tire type? -------------Mudder Issues (problems) with the setup? - Gee, where does one start 1/ - Big Lift 3.5 to 4inches ( I have custom rear coils and extra long travel shockies, and in the front OME heavy duty coils with a clevis lift ) 2/- Big bumpstops in the rear, just about to put big ones in the front, but, not really experiencing difficulties there 3/- I have ARB Front bar, so no issue there, did the usual bashing down the pinch welds I still get some contact where the pich was but not really bad so I'm not concerned about it, also in the rear I have trimmed the rear plastic inner flares, and put in big bumpstops. 4/- I am currently about to instal 4.10 gears, but, is running acceptably with the standard 3.73's |
|
| Author: | 501 [ Mon Apr 14, 2008 9:08 pm ] |
| Post subject: | |
Rim Brand? ----- Stock Rim Size? -------- 16x7 Backspacing? ---- 5.5 Offset? ?? Tire Brand? Firestone Destination Tire Size? 235/70/16 Tire type? AT Issues (problems) with the setup? Only issue I have is, I want bigger tires now that I'm lifted!! |
|
| Author: | KY Liberty [ Mon Apr 14, 2008 9:39 pm ] |
| Post subject: | |
Rim Brand? Jeep Wrangler Moabs Rim Size? 16X8" Backspacing? 5" Tire Brand? Goodyear Wrangler Silent Armor Tire Size? 245/75R16 Load C Tire type? All Terrain Issues (problems) with the setup? Needed Frankenlift II Premium lift with OME HD springs, struts, and long travel shocks. Needed Al's upper control arms for alignment and to eliminate upper ball joint contact. Needed to trim plastic fender well under fog lamp doors. Used the little balancing beads to get the tires balanced. 4.10 gears offset the power loss from the bigger heavier tires. Works extremely well as setup now. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|