LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

HOW MUCH DIFFERANCE IS THERE?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=37314		 Page 1 of 1
Author:  Jeep Dawg [ Wed Nov 12, 2008 10:39 pm ]
Post subject:  HOW MUCH DIFFERANCE IS THERE?
Ok gang,

seriously How much size differance is there from a 29.3" and a 29.5" tire??????
I looked at a 225/75/16 tire and they are all 29.3"
the 245/70/16 is 29.5"
I know the 245 is wider, but the 70 is a lower profile?
Author:  maddawg [ Thu Nov 13, 2008 12:09 am ]
Post subject:  Re: HOW MUCH DIFFERANCE IS THERE?
Jeep Dawg wrote:
Ok gang,

seriously How much size differance is there from a 29.3" and a 29.5" tire??????
I looked at a 225/75/16 tire and they are all 29.3"
the 245/70/16 is 29.5"
I know the 245 is wider, but the 70 is a lower profile?


i just ordered these 245/70/16 i don't have a lift so i hope they fit i read that there should be no problems :?
Author:  Jeep Dawg [ Thu Nov 13, 2008 8:22 am ]
Post subject: 
Well let me know how they work out.
I had a lift with 245\75\16x8 and man I loved the way it drove.
Now that I took out the lift, My old BFG's are worn pretty good. But they were 225/75

why year do you have?
Author:  tommudd [ Thu Nov 13, 2008 10:09 am ]
Post subject:  Re: HOW MUCH DIFFERANCE IS THERE?
Jeep Dawg wrote:
Ok gang,

seriously How much size differance is there from a 29.3" and a 29.5" tire??????
I looked at a 225/75/16 tire and they are all 29.3"
the 245/70/16 is 29.5"
I know the 245 is wider, but the 70 is a lower profile?


so I missed the question, or you sort of answered it yourself, 70s series is wider than a 75 series but the 245 is a taller profile than the 225 so do you want skinny tires or a little wider, look at tread width, big difference. plus if you are going to try and use the Moabs the 225/75s will never work
Author:  Jeep Dawg [ Thu Nov 13, 2008 11:49 pm ]
Post subject:  Re: HOW MUCH DIFFERANCE IS THERE?
I am so freaking confused with tire sizes.
I know the 225's will never work. I was just wondering how much more differance is the 29.0" to the 29.5" tire.....
My KJ is now back to stock height but I want to keep my moabs. I was looking at a 245\70\16 and it measure to 29.5" that is onlt a .2" diff from the 225\75.

now,
is the 245 the width or height of the tire? I thought the 1st group of numbers whas the width and the 2nd set was the height.




tommudd wrote:
Jeep Dawg wrote:
Ok gang,

seriously How much size differance is there from a 29.3" and a 29.5" tire??????
I looked at a 225/75/16 tire and they are all 29.3"
the 245/70/16 is 29.5"
I know the 245 is wider, but the 70 is a lower profile?


so I missed the question, or you sort of answered it yourself, 70s series is wider than a 75 series but the 245 is a taller profile than the 225 so do you want skinny tires or a little wider, look at tread width, big difference. plus if you are going to try and use the Moabs the 225/75s will never work
Author:  501 [ Fri Nov 14, 2008 2:08 am ]
Post subject: 
245 height

70 width
Author:  To_The_Max [ Fri Nov 14, 2008 8:24 am ]
Post subject: 
Hope this helps

http://www.goodyeartires.com/kyt/readingATire/
Author:  InCommando [ Fri Nov 14, 2008 10:23 pm ]
Post subject: 
A 29.5 inch tire is really only .25 inches taller net than a 29.0 inch tire because half of the increase will be below the axle centerline.


245 - section width in MM

75 - aspect ratio : the height of the sidewall is 75% of the section width. A 75 series has a taller sidewall than a 70 series tire, but it does not change the section width*


16 - rim size ( the easy one )


* assuming proper rim width, air pressure etc.

A 245/75/16 tire is taller than a 245/70/16 because the sidewall is 10% taller ( 5% on each side of the axle ) But the taller tire will only make the vehicle sit that 5% taller because, again, 5% is on each side of the axle. it is only 5% taller in any one direction. Both have a section width of 245 mm.

a 245/75/16 is both taller and wider than a 225/75/16 because the section width (245 mm vs. 225 mm ) is wider and the aspect ratio of 75% ( x2 ) of 245 is greater than 75% ( x2) of 225.

section width + aspect ratio conversion (x2) + rim diameter should give you height of tire, IIRC.
Author:  ATXKJ [ Sat Nov 15, 2008 9:49 am ]
Post subject: 
And just to confuse the issue -
what rubs on larger tires is the tread width - that's not part of the formula
and most manufacturers don't tell you tread width, it's proportional to section width - but not the same.
a 245 section width is 9.6 inches but the tread width will commonly be 7.5 to 8.2 -
depends on the tread pattern and the way it's manufactured.
Author:  InCommando [ Sat Nov 15, 2008 3:49 pm ]
Post subject: 
Good point. Aggressive treads make this an even bigger issue.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/