| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| 255/70/16? General Grabber AT2 http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=37544 |
Page 1 of 1 |
| Author: | Robbrez [ Thu Nov 20, 2008 4:24 pm ] |
| Post subject: | 255/70/16? General Grabber AT2 |
is there any rubbing with the 255/70/16 tire? |
|
| Author: | Robbrez [ Thu Nov 20, 2008 4:32 pm ] |
| Post subject: | |
also if you do have this size could you tell me what you get for gas mileage...thankss |
|
| Author: | jsc7002 [ Thu Nov 20, 2008 4:57 pm ] |
| Post subject: | |
I have 245/75/16 which equals out to be about 30.5" and I average about 15 mpg |
|
| Author: | rangerd77 [ Thu Nov 20, 2008 5:09 pm ] |
| Post subject: | |
yeah man i gots dem 31x11.50x15's TSL's and i had to trim alot of my bumper and flares. and believe it or not, i did use a sawsall. and as far as the gas mileage, well im getting about 10mpgs on the average. |
|
| Author: | tjkj2002 [ Thu Nov 20, 2008 5:34 pm ] |
| Post subject: | |
Robbrez wrote: also if you do have this size could you tell me what you get for gas mileage...thankss Depends on the tire and wheel used,besides being taller and wider the overall weight difference will kill your mpg's also.
Regear to 4.10's and it'll lessen the mpg drop. |
|
| Author: | Robbrez [ Thu Nov 20, 2008 5:43 pm ] |
| Post subject: | |
is 255/70/16 a good choice without killing the mileage |
|
| Author: | tommudd [ Thu Nov 20, 2008 5:48 pm ] |
| Post subject: | |
I ran 255-70s for about 24000 miles and didn't notice that much difference over the previous ones maybe a 1/2 mile or so but they were also a very light weight tire, olny like 30/32 lb each so far mines had 235-70 stock junkyears 245-70 before I lifted and a while afterwards 255-70 and now for two days 265-70 but going to 4.10s as soon as I can 
|
|
| Author: | Robbrez [ Thu Nov 20, 2008 5:55 pm ] |
| Post subject: | |
how do your 265/70 do on mileage? |
|
| Author: | tommudd [ Thu Nov 20, 2008 6:12 pm ] |
| Post subject: | |
Robbrez wrote: how do your 265/70 do on mileage?
not sure only went ten miles will do a real check over Thanksgiving when I do a 1700 mile loop ! The 255-70 is about a half inch shorter than the 245-75 that most run just some wider so mileage should be on par with them. Like I said a lot depends on the weight as well |
|
| Author: | Robbrez [ Thu Nov 20, 2008 6:30 pm ] |
| Post subject: | |
do you have any rubbing with the 255/70? |
|
| Author: | tommudd [ Thu Nov 20, 2008 6:42 pm ] |
| Post subject: | |
Robbrez wrote: do you have any rubbing with the 255/70?
No but then I have the ARB out front , but no rubbing at all if you check the pictures section there is a pic posted with the 255-70s but keep in mind I also have the 16X8 Maobs with 5 inch of backspacing which changes everything from the stock wheels |
|
| Author: | Robbrez [ Thu Nov 20, 2008 7:01 pm ] |
| Post subject: | |
what do you think the best tire with little rubbing for me.... i cannot get the 245/75/16 because it is a 10 ply tire and weighs a ton so right now im looking at the 265/70 and the 255/70 if you have any others without rubbing or killing mileage let me know and if you have any of these sizes let me know how you feel about them |
|
| Author: | ATXKJ [ Thu Nov 20, 2008 7:12 pm ] |
| Post subject: | |
245/75/16's don't have to be 10 ply - you can get SL, B,C load grades. from Mileage 2 issues - 1 obviously is weight, the 2nd is that the taller tire changes the effective rearend ratio - so it will get worse mileage unless you drive mainly highway |
|
| Author: | Robbrez [ Thu Nov 20, 2008 8:34 pm ] |
| Post subject: | |
i believe that i can only get the grabber at2's in 10 ply for the 245/75/16 size...let me know if i am wrong on this |
|
| Author: | Robbrez [ Thu Nov 20, 2008 8:53 pm ] |
| Post subject: | |
also can anyone tell me if the 31x10.5 rub i want to start ruling sizes out |
|
| Author: | Inc [ Thu Nov 20, 2008 9:48 pm ] |
| Post subject: | |
I rubbed a bit with my 31x10.5x15 tires on 15" steel wheels with 3.75" backspacing. Not too bad though. |
|
| Author: | Robbrez [ Thu Nov 20, 2008 10:03 pm ] |
| Post subject: | |
im sorry about all the questions but would it rub on the stock bumper because you have an aftermarket bumper...and what do you think about 265/70/16? |
|
| Author: | Inc [ Thu Nov 20, 2008 10:11 pm ] |
| Post subject: | |
I don't rub at all now, I did a little on the stock one, so I cut it down to where it stopped and then put the bumper on. I still think your best bet is a 245/75/16 with a properly back spaced wheel. |
|
| Author: | Robbrez [ Mon Nov 24, 2008 7:18 pm ] |
| Post subject: | |
Just ordered General Grabber AT2's in 31x10.5X15 and a unique D rim (made by the same company that made cragars) will post pics when i get them...should be around monday because of the holiday. 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|