If you want that size then put them on and start cutting
, make darn sure you have bumpstops rear and front though as you will hit the flares when off road for sure with Moabs
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| daystar lift and cut bumper 265/75? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=37678 |
Page 1 of 1 |
| Author: | colts_kj [ Tue Nov 25, 2008 6:00 pm ] |
| Post subject: | daystar lift and cut bumper 265/75? |
I have a daystar lift and i cut the front bumper on an 06 sport. I want to put 265/75s on my moabs. Can i put 265s on without doing a clevis lift or will a clevis lift not even help get me 265s |
|
| Author: | colts_kj [ Wed Nov 26, 2008 1:11 pm ] |
| Post subject: | |
ok ill just try it |
|
| Author: | tommudd [ Wed Nov 26, 2008 2:02 pm ] |
| Post subject: | |
If you want that size then put them on and start cutting , make darn sure you have bumpstops rear and front though as you will hit the flares when off road for sure with Moabs
|
|
| Author: | colts_kj [ Wed Nov 26, 2008 9:05 pm ] |
| Post subject: | |
How much are bumpstops. and are they simple to put on. Is the clevis left worth the time and what can i do to the rear so the front isnt higher than the back |
|
| Author: | dieselenthusiast [ Wed Nov 26, 2008 10:14 pm ] |
| Post subject: | |
colts_kj wrote: How much are bumpstops. and are they simple to put on.
Is the clevis left worth the time and what can i do to the rear so the front isnt higher than the back Add two rear isolators two each side. |
|
| Author: | colts_kj [ Wed Nov 26, 2008 10:40 pm ] |
| Post subject: | |
where can i get the isolators and how do i install them? |
|
| Author: | dieselenthusiast [ Wed Nov 26, 2008 10:53 pm ] |
| Post subject: | |
colts_kj wrote: where can i get the isolators and how do i install them?
You can get them at the Jeep dealership for $7.00 bucks a piece. Here's what they look like 
|
|
| Author: | long_tall_texan [ Thu Nov 27, 2008 1:02 am ] |
| Post subject: | |
dieselenthusiast wrote: You can get them at the Jeep dealership for $7.00 bucks a piece.
That varies by dealer apparently. I checked here in Fort Worth, and they quoted me like $19 each for them. |
|
| Author: | dieselenthusiast [ Thu Nov 27, 2008 1:10 am ] |
| Post subject: | |
long_tall_texan wrote: dieselenthusiast wrote: You can get them at the Jeep dealership for $7.00 bucks a piece. That varies by dealer apparently. I checked here in Fort Worth, and they quoted me like $19 each for them. Actually, I was wrong. I went back to look at my receipt and it shows that I paid $12.00 dollars for each. Part # 52088707AA |
|
| Author: | 2006 KJ [ Thu Nov 27, 2008 10:55 am ] |
| Post subject: | |
i would add 2 rear isolators each side... and do a clevis on the front... that is very cheap insurance.. then put on the 265's and trim as needed |
|
| Author: | colts_kj [ Thu Nov 27, 2008 5:18 pm ] |
| Post subject: | |
well I still may end up doing the lifts but I think i decided to go with 265/70s cooper STT so the height will be the same as my 245s just be an inch or so wider thanks for the help! 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|