i know i remember reading SOMEwhere in here that someone was trying to rig themselves something like this... can someone direct me to the post of this? or if you are the fella that was planning to do this and are reading this, PM me!

_________________
08' KK
modded JBA 4"
255/85 (33s) Maxxis MTs on E.A. 137s
K&N intake, Thrush Turbo, NGK irridium plugs
Surco basket w/ full spare, 4 KCs & Hi-Lift
Cobra CB radio w/ 4' Firestik
------------------------------
90 Renix XJ
Black, 2Door, 4.0, AW4, Np231
d44/d60 swap, detroit rear, spooled front
5.38s with 108" WB on 37" Iroks

i forget the ctual post name but the subject got moved to the libertys being uni-body and having issues with taking the doors off. although there is a thread on another forum and its been mentioned here about a WJ that made half doors, he bought stock doors, cut em up and reinforced the outer edges... that may be an option if you can find a KK at a junk yard without much damage to the doors

_________________
08 Revenge- Rock Lizard (Skink Sliders & Gecko Roof Rails), High Clearance Trimmed Front Bumper, Mopar skids, Riddler Diff Cover, JBA (5.5 Arms, 6" rear Springs, Front Adjust-A-Struts), 32" DuraTracs, Superior 4.56's, Front & Rear ARB Lockers, Fastman Throttle Body, AEM Intake, Hypertech Tune, Custom Ram Air, RunCool Louvers

Try this one viewtopic.php?f=88&t=53441&start=0&hilit=doors+off . I'm not sure if that is what you are looking for but it is related.

_________________
08 Jeep KK Blue. Currently Stock.

You could do it just rig up some quick release pins with a carter pin to hold it in there. Drill your old ones out including the one holding the door assit and replace them all. Next just wire in the quick disconnects for the wiring harness and you can remove them easily every single time.

_________________
My CRD Build Thread
Soon to Come:more lights

Very important if you do it. We would like a write up

I would be concerned of the flex (damage the unibody).

_________________
08 Jeep KK Blue. Currently Stock.