LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Mounting Mag Lite in KK?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=40921		 Page 1 of 2
Author:  ups4 [ Thu Mar 05, 2009 11:02 pm ]
Post subject:  Mounting Mag Lite in KK?
Anybody have a suggestion on where to mount a 3-cell Mag Lite in the KK?
I would like to have it in the front compartment somewhere, but the suggestions I've seen for the KJ are on the drivers seat frame. I like this idea, but it doesn't seem to fit very well on the KK.

Paul
Author:  Diggerfreek [ Thu Mar 05, 2009 11:11 pm ]
Post subject: 
I haven't gotten around to that mod yet :D
Author:  ups4 [ Thu Mar 05, 2009 11:39 pm ]
Post subject: 
Well, ever since I had to change a flat the other day in the dark I decided it's something that I should finally do.

FYI. I found a 3-cell Mag Lite with mounting clips, mini Mag, and batteries for both at Sam's Club for about $20. Had them in 4 colors, but I just went with the black....it's traditional :wink: .

Paul
Author:  Diggerfreek [ Thu Mar 05, 2009 11:55 pm ]
Post subject: 
you could always throw it in to the little tray in the rear on the right or put ti in with the jack. I keep a little bag of tool in there
Author:  MNKK [ Fri Mar 06, 2009 4:49 pm ]
Post subject: 
Thats where mine is! in the tray.
Author:  ups4 [ Fri Mar 06, 2009 10:04 pm ]
Post subject: 
MNKK wrote:
Thats where mine is! in the tray.

Yeah, right now it's just sitting in the tray back there....and that's not too bad. I just want to use the clips since they came with the kit :lol: .

There are a couple of decent spots in the back area that look strong enough to drill into and attach the clips. I may have to go that route after all.

Paul
Author:  Diggerfreek [ Fri Mar 06, 2009 10:11 pm ]
Post subject: 
where are you going to drill. If it's on the left, cool... but right side has a couple main wire arteries running along the panel
Author:  ups4 [ Fri Mar 06, 2009 10:49 pm ]
Post subject: 
Thanks for that important piece of info Digger :shock: . I was wondering what would be up under the plastic panels. The left side is where the jack door is, but I think it would fit right underneath the door...kinda laying on the floor but attached to the trim.

I was looking at the right side right in front of the little pocket thingy. I have a small dustbuster vac in the pocket now....with the mag for the time being. Where exactly is the wiring? There is a pretty sturdy lip on the pocket, and I think it might do good there....no?

Paul
Author:  MNKK [ Fri Mar 06, 2009 10:56 pm ]
Post subject: 
I have a small fire extinguisher mounted on the left side, in the window area. It worked really well. I marked the holes, after I felt around in there on the under side. Drilled, and used small bolts with nuts, and washers. Really fit nicely in there.
I would like to get those rear 4 windows blacked out eventually. I think it would be a little less tempting for passers by. Heck, I even want to break the window, and trigger the extinguisher, every now and then. :lol: :? :shock:
Author:  ups4 [ Fri Mar 06, 2009 11:44 pm ]
Post subject: 
MNKK wrote:
Heck, I even want to break the window, and trigger the extinguisher, every now and then. :lol: :? :shock:

Careful...the Amstaff Terrier might bite your hand off :wink: .

Paul
Author:  stripesace [ Sat Mar 07, 2009 12:12 am ]
Post subject: 
I'm looking for a spot by the drivers door to mount my brackets... thats where i stashed my mag lite in my toyota corolla... cept it moved around ab it.

some KJ owners have em mounted under the seat next to the door.
Author:  GermanKK [ Sat Mar 07, 2009 4:15 am ]
Post subject: 
I had a MagCharger installed on the side of the driver seat in my Rubicon, I am searching for a good spot in my KK.
I need a little more space for the charger preferably with a power supply not to far away.
If anybody has an idea, please let me know. My idea is under the rear seats/bench.

Andree
Author:  ups4 [ Sat Mar 07, 2009 1:58 pm ]
Post subject: 
I was considering one of these two places for my Mag Lite.

Image

OR

Image


Paul
Author:  E2 [ Sat Mar 07, 2009 3:31 pm ]
Post subject: 
I would go with next to the seat. why's mag light? it so big. did you get the led type? it's brighter and the batteries will last so much longer! the make conversion kit for about $20. make sure you get the max watts (I think 3watts for a e cell)
Author:  ups4 [ Sat Mar 07, 2009 4:26 pm ]
Post subject: 
E2 wrote:
I would go with next to the seat. why's mag light? it so big. did you get the led type? it's brighter and the batteries will last so much longer! the make conversion kit for about $20. make sure you get the max watts (I think 3watts for a e cell)

Yeah, it is big, but it's sturdy. I've always like the Mags for durability. It can also be used as a weapon if needed :wink:.

The only problem I see with the front mount is the clearance with the door and the seat. It seems pretty tight. I'm also worried about accessibility with the door closed...although it's not likely to need it with the door closed.

Meh...it's not that big a deal. I'll just get er done one way or another and that'll be that. I was just wondering what others might have done with theirs.

Paul
Author:  Diggerfreek [ Sat Mar 07, 2009 7:31 pm ]
Post subject: 
If I had a spare 140 laying around, I would mount a Streamlite Stinger DS LED next to it. It is just as sturdy as a mag and I love the one I have at work. 10x or even 100x brighter than a mag. Plus it has a strobe feature built in to it's programing :twisted:
Author:  ups4 [ Sat Mar 07, 2009 8:48 pm ]
Post subject: 
Now that's ^^^^ a torch!! :shock:

Paul
Author:  Mike08Liberty [ Sat Mar 07, 2009 9:02 pm ]
Post subject: 
I wouldn't mount it where it was visible from the outside. It doesn't take much to give some degenerates a reason to break a window. I would just toss it under the driverseat or put in where the spare is or see if it would fit in the glove box.

I keep one of these and a small handheld 1 watt LED flash light in the middle console
Hands free
Image
Author:  ups4 [ Sun Mar 08, 2009 9:03 pm ]
Post subject: 
In case anybody's interested, I ended up mounting the Mag Lite by the drivers seat and it works perfectly.
Nice and handy and it isn't in the way of me getting my big size 13's in the Jeep :D . I would recommend this placement if you're looking to mount one.

Paul
Author:  stripesace [ Sun Mar 08, 2009 9:41 pm ]
Post subject: 
ups... care to give us some ideas on how you got it on there?
Page 1 of 2 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/