LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

KK ground clearance
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=41404
Page 1 of 1

Author:  hyedipin [ Fri Mar 20, 2009 7:14 pm ]
Post subject:  KK ground clearance

Is it true that it has 2" less ground clearance than KJ?

Author:  Boblemoche [ Fri Mar 20, 2009 9:50 pm ]
Post subject: 

isnt the 8.25 the lowest point on a kj / kk

Author:  E2 [ Fri Mar 20, 2009 10:02 pm ]
Post subject:  My Measurements

http://www.einemphotography.com/myphotos/2008KK/clearances-stock.jpg

Author:  Diggerfreek [ Fri Mar 20, 2009 10:29 pm ]
Post subject: 

you have to account for spring sag on your measurements. The front diff moves quite a bit after the suspension settles

Author:  hyedipin [ Sat Mar 21, 2009 12:43 am ]
Post subject: 

E2, that's a nice drawing, thanks.

I checked around a bit and Cars.com states that KJ has 9.5 " and KK has 7.8 "
I didn't think there could be this big difference..
http://www.cars.com/go/compare/trimComp ... 90JES132B0

Author:  hrogi [ Sat Mar 21, 2009 11:32 am ]
Post subject: 

Jeep number stated this.

Sport 8.0 inches
Limted 7.8 inches.

Now what is needed for fire roads and beach cruzing?

Author:  Boblemoche [ Sat Mar 21, 2009 1:23 pm ]
Post subject: 

hyedipin wrote:
E2, that's a nice drawing, thanks.

I checked around a bit and Cars.com states that KJ has 9.5 " and KK has 7.8 "
I didn't think there could be this big difference..
http://www.cars.com/go/compare/trimComp ... 90JES132B0


I doubt there is that much difference overall mabe at a particular point yes but not overall. however , I must say that the KK gas tank is in the way just like the jk and every newer veichles and a gas tank skid is mandatory for offroad use

Author:  E2 [ Sat Mar 21, 2009 9:30 pm ]
Post subject: 

Diggerfreek wrote:
you have to account for spring sag on your measurements. The front diff moves quite a bit after the suspension settles


My measurements were taken at about 5000 miles. I have other measurements for the rubicon (245/75r16), a tacoma (non-4x4) and a 1985 landcrusier that I took to compair and figure out what height I need in a lift.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/