Hi everyone!
Im going to make this short:
My new mod is a very VERY simple (yet effective) alarm... I bought it so that my KK would be protected with a shock sensor... its quite loud, and the install could not have been any simpler... you just plug in your positive and negative battery posts and voila!
it comes with two remotes for arming and disarming and a sensitivity level to adjust the shock sensor.
here's the link:
http://www.quadratec.com/products/15002_00.htm
and here are the pics:






And regarding my new issue:
There's a clip on the bottom of the drivers side seat that keeps falling out of place:
here are the pics:









Has anyone experienced something similar? Im thinking that I should put some hot glue and attach...
any ideas?
thanks!

_________________
2009 4x4 Silver Liberty Limited Edition, Premium Group I and II, Skid Plate Group, Exterior Appearance Group by MOPAR, Select Trac II, Sky Slider,uconnect studios,Slush Mats, Hid HEADLAMPS, Interior LED light mod, Scangauge 2, AEM brute force intake, IPOD Integration interface for RER RADIOS, OEM Front end bra.

Well if the clip will not stay on and car is out of warranty or you do not want the dealer to screw it up more, then glue would work.
or
heat up the plastic and close the gap more, to make a tighter fit.
Or use a string to keep it in place.
Run the string through the piece and tie it off.
or drill a few holes in it and attach a few springs to hold it in place.

_________________
2008 Liberty Limited 4X4 Command Trac 2
All stock Auto with 235/60/18

well, the jeep has to be under warranty since I just bought it new this last December.... so...
I guess Ill pay the dealer a visit

_________________
2009 4x4 Silver Liberty Limited Edition, Premium Group I and II, Skid Plate Group, Exterior Appearance Group by MOPAR, Select Trac II, Sky Slider,uconnect studios,Slush Mats, Hid HEADLAMPS, Interior LED light mod, Scangauge 2, AEM brute force intake, IPOD Integration interface for RER RADIOS, OEM Front end bra.

Dont PAY them anything!!! Lol