LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

New Mod, New Issue
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=43930		 Page 1 of 1
Author:  SilverKK09 [ Sun Jun 07, 2009 12:41 pm ]
Post subject:  New Mod, New Issue
Hi everyone!
Im going to make this short:
My new mod is a very VERY simple (yet effective) alarm... I bought it so that my KK would be protected with a shock sensor... its quite loud, and the install could not have been any simpler... you just plug in your positive and negative battery posts and voila!
it comes with two remotes for arming and disarming and a sensitivity level to adjust the shock sensor.
here's the link:
http://www.quadratec.com/products/15002_00.htm
and here are the pics:
Image

Image

Image

And regarding my new issue:
There's a clip on the bottom of the drivers side seat that keeps falling out of place:
here are the pics:

Image

Image

Image

Image

Has anyone experienced something similar? Im thinking that I should put some hot glue and attach...
any ideas?
thanks!
Author:  hrogi [ Sun Jun 07, 2009 12:50 pm ]
Post subject: 
Well if the clip will not stay on and car is out of warranty or you do not want the dealer to screw it up more, then glue would work.
or
heat up the plastic and close the gap more, to make a tighter fit.
Or use a string to keep it in place.
Run the string through the piece and tie it off.
or drill a few holes in it and attach a few springs to hold it in place.
Author:  SilverKK09 [ Sun Jun 07, 2009 1:49 pm ]
Post subject: 
hrogi wrote:
Well if the clip will not stay on and car is out of warranty or you do not want the dealer to screw it up more, then glue would work.
or
heat up the plastic and close the gap more, to make a tighter fit.
Or use a string to keep it in place.
Run the string through the piece and tie it off.
or drill a few holes in it and attach a few springs to hold it in place.

well, the jeep has to be under warranty since I just bought it new this last December.... so...
I guess Ill pay the dealer a visit
Author:  badazzelanore [ Wed Jun 10, 2009 2:44 pm ]
Post subject: 
SilverKK09 wrote:
hrogi wrote:
Well if the clip will not stay on and car is out of warranty or you do not want the dealer to screw it up more, then glue would work.
or
heat up the plastic and close the gap more, to make a tighter fit.
Or use a string to keep it in place.
Run the string through the piece and tie it off.
or drill a few holes in it and attach a few springs to hold it in place.

well, the jeep has to be under warranty since I just bought it new this last December.... so...
I guess Ill pay the dealer a visit


Dont PAY them anything!!! Lol
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/