hrogi wrote:
use zip ties.
just use really strong ones...
Just Joking....
just use really strong ones...
Just Joking....
Im using zip ties to install my winch...... That should hold it in place....
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Fuel Tank skid nut http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=44507 |
Page 1 of 1 |
| Author: | wingnuts [ Fri Jun 26, 2009 12:51 pm ] |
| Post subject: | Fuel Tank skid nut |
Digger or anyone else that may know. I got my fuel tank skid this week, thanks to another LOST member, but I am missing one nut and just curious to know if it is galvinized? Nut I am missing is part D on the instructions that I can't seem to post the link to because I am using the Wife's mac right now and I don't get this thing. Anyway it is on www.justforjeeps.com I should just forget this post all together, I can't post all the information that I have, need to go find my PC. |
|
| Author: | KKeith [ Fri Jun 26, 2009 6:11 pm ] |
| Post subject: | |
Take a nut of the old fuel tank support, they are the same. |
|
| Author: | wingnuts [ Fri Jun 26, 2009 6:15 pm ] |
| Post subject: | |
Ok thanks, I hadn't looked to see if they were or not. |
|
| Author: | KKeith [ Fri Jun 26, 2009 6:29 pm ] |
| Post subject: | |
Take a nut of the old fuel tank support, they are the same. |
|
| Author: | hrogi [ Fri Jun 26, 2009 7:36 pm ] |
| Post subject: | |
use zip ties. just use really strong ones... Just Joking.... |
|
| Author: | SilverKK09 [ Fri Jun 26, 2009 7:38 pm ] |
| Post subject: | |
hrogi wrote: use zip ties.
just use really strong ones... Just Joking.... Im using zip ties to install my winch...... That should hold it in place....
|
|
| Author: | rickm [ Sat Jun 27, 2009 4:21 pm ] |
| Post subject: | |
I don't think it would be a galvanized nut, I doubt they use those. Maybe zinc plated, but not galvanized, I don't think. Why not just put a plated, rust resistant nut on there, or do you want them all to match? |
|
| Author: | hrogi [ Sat Jun 27, 2009 4:27 pm ] |
| Post subject: | |
It is always better to have Matching nuts. So when people inspect your nuts they have less questions.... Ok just joking... Just have a good nut that will not rust. then paint over it.. so it wil not back off on it own. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|