| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| is there a how to on http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=53456 |
Page 1 of 1 |
| Author: | Jeepin_it_real [ Fri Jun 11, 2010 8:21 am ] |
| Post subject: | is there a how to on |
is there a how to on jba arms... if not what tools do i need, people keep telling me i need this special fork thing??? |
|
| Author: | Elt31987 [ Fri Jun 11, 2010 9:06 am ] |
| Post subject: | Re: is there a how to on |
Nope, the Pass Side is easy, just remove the air box and remove the 2 bolts, the driver side bolt that is towards the front is also easy, the back drivers side bolt you will need an extension and a Universal connection to get a better angle then go in from the front of the Jeep rite where the front driver bolt is. I dont remember if you need to remove the battery. I can look after work and tell you |
|
| Author: | Diggerfreek [ Sun Jun 13, 2010 5:26 am ] |
| Post subject: | Re: is there a how to on |
To pop the ball joint, just smack the part of the knuckle the ball joint goes in to to release it.... |
|
| Author: | Jeepin_it_real [ Thu Jun 17, 2010 6:05 pm ] |
| Post subject: | Re: is there a how to on |
so i attemtper this today but failed.... that rear driver side bolt is a real pain... i figured id start there... good thing too... i cant figure out how to get the socket on it and have enough room to actually turn the ratchet... i can get the socket on it but i never have any room to really move the ratchet... i feel like the steering rack or abs pump are in the way.... any suggestions or explanations on what to do... even pics would help... anything really lol |
|
| Author: | Jeepin_it_real [ Thu Jun 17, 2010 6:06 pm ] |
| Post subject: | Re: is there a how to on |
as a note i had both the fuse box and the battery/tray out |
|
| Author: | Elt31987 [ Thu Jun 17, 2010 7:32 pm ] |
| Post subject: | Re: is there a how to on |
I used an Air Ratchet but there was still VERY LITTLE room to actually manually crank it. |
|
| Author: | Scar0 [ Thu Jun 17, 2010 8:27 pm ] |
| Post subject: | Re: is there a how to on |
U-joint and a long extension is how I did mine. It was still a PIA, but it worked. |
|
| Author: | Jeepin_it_real [ Thu Jun 17, 2010 10:27 pm ] |
| Post subject: | Re: is there a how to on |
yeah air ratchet may be the way to go... i didnt even think of that ( and i have one too) stupid me |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|