How do you add new speaker Wire in doors

Mikey Russell · **Joined:** Sat Jan 30, 2010 5:48 pm **Posts:** 34

Hi all,

I'm upgrading my stereo, the deck is in and working great. The amp is wired except to the battery. I have two new Polk DB651 in the rear doors and waiting on my Polk DB 6501's. Since I have the rears I wanted to run 16 guage wire from the all doors to the amp. My problem is I can't find a way of doing this with drilling. I thought the gromet/boot went from inside the jeep to the door but in the middle there is a hard plastic connection that plugs in from both sides.
Has anyone added new speaker wire to their doors and if so how...please.

Thanks

DirtyKK · **Posted:** Sun Aug 01, 2010 5:03 am

Come on drilling holes isn't that bad. :twisted:

In all honesty I haven't looked but I will see if I can come up with somethin. Seriously though, drilling a small hole for speaker wiring next to the factory wiring would be fine. You could pry find rubber grommets to put in them and it'll look mostly stock too.

Mikey Russell · **Joined:** Sat Jan 30, 2010 5:48 pm **Posts:** 34

I was looking at cutting under the factory gromet and but that is a tight fit to cut witout removing the door. Plus I would need to be extremely careful not to nic any of the wiring already there.

Quicksilversurf917 · **Posted:** Sun Aug 01, 2010 5:56 pm

yea just drill a tiny hole big enough to fit the wire, it should hurt anything...

by the way good speaker choice, I have the same front and rears also, and with the tweeters

How do you add new speaker Wire in doors

Who is online