| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Intake Resonator Removal? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=61228 |
Page 1 of 1 |
| Author: | remdawg [ Wed Jun 15, 2011 8:37 pm ] |
| Post subject: | Intake Resonator Removal? |
I am planning on Sea Foaming the Jeep this weekend and wanted to poke around beforehand so I could get an idea of what I'll need to do. I noticed that I can't really get to the throttle body without removing the intake resonator. When I went to remove the resonator, I couldn't get to the Torx screws holding the box in place. Does anyone have any advice/help for this (hopefully the CAI folks)?? |
|
| Author: | Jeepin_it_real [ Thu Jun 16, 2011 4:58 pm ] |
| Post subject: | Re: Intake Resonator Removal? |
to remove the air box you literally just pull after disconnecting it from the intake pip that connects to the throttle body.. make sure no moisture gets in there though or if it does dry it |
|
| Author: | hrogi [ Thu Jun 16, 2011 7:24 pm ] |
| Post subject: | Re: Intake Resonator Removal? |
Stupid question here... Are you going to clean the throttel body butter fly? Then, Introduce the Sea Foam through a Vacumn line? |
|
| Author: | mag03kj [ Thu Jun 16, 2011 7:25 pm ] |
| Post subject: | Re: Intake Resonator Removal? |
Why SeaFoam an almost brand new vehicle? |
|
| Author: | remdawg [ Thu Jun 16, 2011 11:59 pm ] |
| Post subject: | Re: Intake Resonator Removal? |
I'm going to sea foam through the brake booster, and then spray some deep creep into the throttle body fly... Also, my Jeep has 64k miles on it so I don't really consider it that new anymore
|
|
| Author: | remdawg [ Fri Jun 17, 2011 8:26 am ] |
| Post subject: | Re: Intake Resonator Removal? |
http://www.youtube.com/watch?v=zt_oXKxe3wo This will be the guide I'm following... |
|
| Author: | Mike08Liberty [ Sat Jun 18, 2011 12:48 pm ] |
| Post subject: | Re: Intake Resonator Removal? |
Careful spraying the stuff into the throttle body butterfly, if you spray too much at one time it will bog down the engine and it will cut off. You'll want to keep the spray nozzle back a few inches and spray a little at a time. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|