Diy rear shims/isolators

At The Helm · **Posted:** Thu Nov 10, 2011 11:18 pm

I had an old cutting board laying around and put it to good use with the help of hole saws.

The poly cutting board was suprisingly a little bit brittle, but i think they'll hol up sandwiched between the isolators.

smigelskijk · **Posted:** Fri Nov 11, 2011 8:37 am

How are they holding up for you?

At The Helm · **Posted:** Fri Nov 11, 2011 8:29 pm

Well its been one day and so far so good.

tommudd · **Posted:** Mon Nov 14, 2011 12:20 am

I used a cutting board to make front top plates ( to prove a point to someone :ROTFL:

) and they worked for over 5000 miles until I took them out I'm sure they took more abuse up front than what your rears will.
Good luck :wink: