I had an old cutting board laying around and put it to good use with the help of hole saws.
The poly cutting board was suprisingly a little bit brittle, but i think they'll hol up sandwiched between the isolators.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Diy rear shims/isolators http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=63616 |
Page 1 of 1 |
| Author: | At The Helm [ Thu Nov 10, 2011 11:18 pm ] |
| Post subject: | Diy rear shims/isolators |
I had an old cutting board laying around and put it to good use with the help of hole saws. The poly cutting board was suprisingly a little bit brittle, but i think they'll hol up sandwiched between the isolators. |
|
| Author: | smigelskijk [ Fri Nov 11, 2011 8:37 am ] |
| Post subject: | Re: Diy rear shims/isolators |
How are they holding up for you? |
|
| Author: | At The Helm [ Fri Nov 11, 2011 8:29 pm ] |
| Post subject: | Re: Diy rear shims/isolators |
Well its been one day and so far so good. |
|
| Author: | tommudd [ Mon Nov 14, 2011 12:20 am ] |
| Post subject: | Re: Diy rear shims/isolators |
I used a cutting board to make front top plates ( to prove a point to someone  ) and they worked for over 5000 miles until I took them out I'm sure they took more abuse up front than what your rears will. Good luck 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|