Hey peeps!

Got a question:
I will be getting the 1.5 OME spring lift kit within the next month or so (already ordered, just waiting on parts)

I have been thinking of getting Boilers front 3/8" shims to get a little extra lift.
Chip mentioned that I would have to get Mopar rear top spring iso's and that it would have to be 3 iso's per side......noob question(s) but.....

Is this a good idea, is it safe...will this negatively effect the ride/handling of the jeep? Will this in any way negatively effect the lift kit (springs, shocks etc) ?

Any input would be much appreciated!

_________________
Ian
2008 KK Sport 4x4
OME HD/MD Lift (2.25inches)
Tires : LT 245/75/R16 Goodyear Wrangler DuraTrac's
Speakers: Alpine SC600's component front, Coax rear

Works on KJs great, have installed 2 extra uppers per side on about 20 of them so far.
Not sure on the KKs

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Works great just like Tom said. One of my 4 inch prototype lifts ran spacers at one point.

_________________
2008 KK Liberty Sport NIGHT OPS EDITION + GILLS
OEM & Custom Skids - Factory Tow Package - Rock Lizard Skink Super Sliders
Prototype JBA 4 Inch Lift - JBA UCA's - Flowmaster Super 44 OR - Whacked Resonator
Jet Stage 2 - RL Gecko Basket Rack - Custom Winch Bumper - Recon 10.5K Winch