LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Will tapping into wires to add interior LED's void warranty?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=64395		 Page 1 of 1
Author:  baseballflash5 [ Thu Dec 29, 2011 10:30 am ]
Post subject:  Will tapping into wires to add interior LED's void warranty?
Thinking about adding LED's under the dash by tapping into the cigarette lighter wires, but I don't want to do it if it will void the warranty.
Author:  Diggerfreek [ Thu Dec 29, 2011 12:33 pm ]
Post subject:  Re: Will tapping into wires to add interior LED's void warra
Depends on your servicing dealer. Should something fail, that dealer must prove that your splice was the cause of failure...

I pull give or take 6 amps or juice off of the cig lighter when I turn on my over head lights. I power my interior switches which operate the low amp side of the relays for my lights. I have run my upper lights for long periods of time with out issue. As a matter of fact, I run my lights 10 to 15 minutes every morning when I drive to work on the dark country roads.....
Author:  musclezmarinara [ Thu Dec 29, 2011 2:15 pm ]
Post subject:  Re: Will tapping into wires to add interior LED's void warra
Diggerfreek wrote:
Depends on your servicing dealer. Should something fail, that dealer must prove that your splice was the cause of failure...

I pull give or take 6 amps or juice off of the cig lighter when I turn on my over head lights. I power my interior switches which operate the low amp side of the relays for my lights. I have run my upper lights for long periods of time with out issue. As a matter of fact, I run my lights 10 to 15 minutes every morning when I drive to work on the dark country roads.....

You have lamps on the roof? PICS ? DIY :)
Author:  Diggerfreek [ Thu Dec 29, 2011 2:29 pm ]
Post subject:  Re: Will tapping into wires to add interior LED's void warra
musclezmarinara wrote:
Diggerfreek wrote:
Depends on your servicing dealer. Should something fail, that dealer must prove that your splice was the cause of failure...

I pull give or take 6 amps or juice off of the cig lighter when I turn on my over head lights. I power my interior switches which operate the low amp side of the relays for my lights. I have run my upper lights for long periods of time with out issue. As a matter of fact, I run my lights 10 to 15 minutes every morning when I drive to work on the dark country roads.....

You have lamps on the roof? PICS ? DIY :)



I have a rock lizard fab gecko rack on my KK with 4 hella 500's up there

Image
Image
Author:  KK_Canuck_Guy [ Thu Dec 29, 2011 4:28 pm ]
Post subject:  Re: Will tapping into wires to add interior LED's void warra
I have a rock lizard fab gecko rack on my KK with 4 hella 500's up there

Image
Image[/quote]


darn Nathan!

Been a while since i've browsed around on here (pretty much been MIA a couple months after I joined on here) but......she's lookin good!!
Author:  Diggerfreek [ Thu Dec 29, 2011 4:41 pm ]
Post subject:  Re: Will tapping into wires to add interior LED's void warra
Thanks :wink:

Here is a head on shot next to my "twin"


Image
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/