LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Rear top spring isolators with OME 1.5 inch lift?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=64400		 Page 1 of 1
Author:  KK_Canuck_Guy [ Thu Dec 29, 2011 4:25 pm ]
Post subject:  Rear top spring isolators with OME 1.5 inch lift?
Hey peeps!

Got a question:
I will be getting the 1.5 OME spring lift kit within the next month or so (already ordered, just waiting on parts) :BANANA:

I have been thinking of getting Boilers front 3/8" shims to get a little extra lift.
Chip mentioned that I would have to get Mopar rear top spring iso's and that it would have to be 3 iso's per side......noob question(s) but.....

Is this a good idea, is it safe...will this negatively effect the ride/handling of the jeep? Will this in any way negatively effect the lift kit (springs, shocks etc) ?

Any input would be much appreciated!
Author:  tommudd [ Thu Dec 29, 2011 5:03 pm ]
Post subject:  Re: Rear top spring isolators with OME 1.5 inch lift?
Works on KJs great, have installed 2 extra uppers per side on about 20 of them so far.
Not sure on the KKs
Author:  Diggerfreek [ Thu Dec 29, 2011 8:50 pm ]
Post subject:  Re: Rear top spring isolators with OME 1.5 inch lift?
tommudd wrote:
Works on KJs great, have installed 2 extra uppers per side on about 20 of them so far.
Not sure on the KKs



Works great just like Tom said. One of my 4 inch prototype lifts ran spacers at one point.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/