Time to lift it and install JBA's adjustable rear track bar
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Will this fit? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=64607 |
Page 1 of 1 |
| Author: | JEEPIN36COKK [ Tue Jan 10, 2012 11:00 pm ] |
| Post subject: | Will this fit? |
http://www.yourcovers.com/diffcover_9864.php Found this Diff Cover for chrysler/dodge 8.25, 10 bolt? looks like it can fit a KJ, its 3.98 from mounting surface to outer edge of ribs? Just curious if it might fit a KK? Found this while looking at a replacement trans pan for 42RLE. |
|
| Author: | Diggerfreek [ Thu Jan 12, 2012 8:37 am ] |
| Post subject: | Re: Will this fit? |
It should fit. The only problem I see is the track bar possible hitting it, but I think it is far enough off set not to hit it.... |
|
| Author: | JEEPIN36COKK [ Fri Jan 13, 2012 11:03 pm ] |
| Post subject: | Re: Will this fit? |
Monday, looks like a good day to break out the tape measure and see. |
|
| Author: | JEEPIN36COKK [ Sat Jan 21, 2012 9:29 pm ] |
| Post subject: | Re: Will this fit? |
Well, unless I can't read a tape measure no more, there was only a little over 3 inches between diff mounting surface and track bar, so I think this ones a no go. |
|
| Author: | Diggerfreek [ Sat Jan 21, 2012 9:34 pm ] |
| Post subject: | Re: Will this fit? |
Time to lift it and install JBA's adjustable rear track bar
|
|
| Author: | JEEPIN36COKK [ Sat Jan 21, 2012 10:41 pm ] |
| Post subject: | Re: Will this fit? |
And so it would begin...wouldn't have any old smaller lift parts laying around you don't need anymore do ya?????? 
|
|
| Author: | Diggerfreek [ Sat Jan 21, 2012 10:46 pm ] |
| Post subject: | Re: Will this fit? |
I wish i did, but I only have a few OEM parts left.... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|