wondering if others can give me a hand here. my 08 liberty e-brake andle pulls up like 1/2-3/4 of the way before doing anything. is this just the way it is or is somthing wrong so i did the rear brakes yester day cleaned the e-brake never seized the baking plate adjusted them up but it is still this way, took the consol apart and found there is no adjustment there at all what do i do? what kinda handle travel do you guys get.?

never mind... i took the handle out found that the auto cable adjust was not working correctly bent the kick back tab back seems to be holding good now 3 clicks just where i like it.

Can you show pictures of what you're talking about here? I have taken mine apart before and discovered I didn't have an auto-adjustment...I was pretty sure the KKs didn't have one. I don't think the US ones are any different from the CAN ones either...??

_________________
2008 Jeep Liberty, ABS Cut-off Switch, 235/70R16, Trans Temp Gauge, Oil Pressure Gauge
Hanging in Vancouver, WA

well not with out taking my consol apart. your poblem is the same you have no activation till the top half of the stroke? feels like it is not tuging on anything.

Here is a Pic of it for you.
Be very cautious of the wires under there! The black box is part of the SRS Air-Bag system. There was a KA owner who popped off his side curtain air-bags by messing with the wires.
It would be best to disconnect the Neg (-) battery cable first, and wait 10 minutes before getting in there.
Don't bend the tab too much or you could cause the brakes to bind continuously, or the spring to jump over it, or worse, break the tab and you will be getting a new lever.

_________________
07 KA Light Khaki, Manual trany.
2.5" Adjust-A-Strut JBA lift, Euro taillights,
Home made; Front Tilt Hood, Roof Rack, RAM Air, & CAI.
ESP Off Switch
Take a ride on the Trō side!