LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Lift Modifications?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=70686		 Page 1 of 1
Author:  Voyager [ Sun Sep 02, 2012 10:02 am ]
Post subject:  Lift Modifications?
I have a 2010 KK that currently has 40,000 miles on it that I lifted last year with the Rock Krawler 3.5 Inch X Factor System. I know the negative rep this lift has, but it's what I went with when I did it last year. Thing is, however, the front of the Jeep sits one inch lower than the back. My simple question is this. Which would be the better of the options I'm considering for getting the Jeep level? Adjusting the clevis, getting new OEM front springs, or ditching the Rock Krawler clevis outright and going with Old Man Emu or Iron Man lift springs up front? I don't have a lot of extra money to spend, so I plan on leaving the rear spacer as is for now.
Author:  At The Helm [ Sun Sep 02, 2012 10:36 am ]
Post subject:  Re: Lift Modifications?
What are the measurements front and rear from the center of the wheel to the bottom edge of the fender flare?
You can add a 1/4" top plate and gap the clevis 1/4" to give you about 1" of front lift.
But, you can only go so high before the factory uca's hit the spring.
Author:  Voyager [ Sun Sep 02, 2012 11:16 am ]
Post subject:  Re: Lift Modifications?
Front: 20.25"
Rear: 21"
Author:  At The Helm [ Sun Sep 02, 2012 11:29 am ]
Post subject:  Re: Lift Modifications?
Putting a 3/8" gap in the clevis would be the easiest way to level it out.
If you are considering a full spring lift i suggest saving up till you can upgrade the shocks too and get it done at once. You could do the front first then wait to do the rear. Thats what i'm doing.
Author:  Voyager [ Sun Sep 02, 2012 9:44 pm ]
Post subject:  Re: Lift Modifications?
Thanks!
Author:  tommudd [ Sun Sep 02, 2012 10:16 pm ]
Post subject:  Re: Lift Modifications?
Just do an OME full spring lift with new shocks and you'll have the lift and a whole lot better ride as well :wink:
Author:  musclezmarinara [ Tue Sep 04, 2012 10:43 pm ]
Post subject:  Lift Modifications?
Old man emu springs and Bilsteins are working quite well for me sir
Author:  Voyager [ Sun Sep 09, 2012 12:01 am ]
Post subject:  Re: Lift Modifications?
Atthehelm wrote:
Putting a 3/8" gap in the clevis would be the easiest way to level it out.
If you are considering a full spring lift i suggest saving up till you can upgrade the shocks too and get it done at once. You could do the front first then wait to do the rear. Thats what i'm doing.


If I were to go this route, would I be able to get the Jeep level. That's the most important thing for me right now. I can't stand the forward leaning stance.
Author:  DirtyKK [ Sun Sep 09, 2012 12:26 am ]
Post subject:  Re: Lift Modifications?
Do the clevis lift. Upgrade when you can afford it
Author:  At The Helm [ Sun Sep 09, 2012 12:36 am ]
Post subject:  Re: Lift Modifications?
Hard for me to say for sure.
But i will say this:
Ome 927s with one conduit nut per side and my 70lb steel bumper puts me at 21 1/8" on the driver side and 21 7/8" on the passenger side. I can't remember the exact measurements with the bumper and no clevis lift, but i think it was 21-21.5"
So i think 927s should make it levelish with no extra clevis lift, within 1/4-3/8" variance from the rear after it settles. You could add an extra isolator to the rear to bring it up 1/4" or so. When you put in the rear spacers did you move the lower spring isolator to the top or not use it? You can stack two iso's on the top of the rear springs.
Author:  Voyager [ Sun Sep 09, 2012 4:18 pm ]
Post subject:  Re: Lift Modifications?
Figured I'd put a pic up to show just how front forward the Jeep leans. I Used a grid layer in Photoshop to further illustrate it. The tech basically lifted the Jeep, but kept the factory rake. Some may like this appearance, but I don't.

Image
Author:  musclezmarinara [ Sun Sep 09, 2012 5:18 pm ]
Post subject:  Lift Modifications?
Looks good but I'm more for level lift overall
Author:  Roastbeef [ Sun Sep 09, 2012 5:30 pm ]
Post subject:  Re: Lift Modifications?
Has the front sagged down like that since you installed the lift or is this a new thing?
Author:  tommudd [ Sun Sep 09, 2012 6:34 pm ]
Post subject:  Re: Lift Modifications?
You use a lift that gave you the same amount of lift front and rear
it had a forward rake before so of course it would have it afterwards
Clevis lift of 3/8 of an inch gives you 3/4 inch of lift
of course then another alignment will be needed afterwards
Author:  Voyager [ Tue Sep 11, 2012 8:44 am ]
Post subject:  Re: Lift Modifications?
Question:

Floating or conduit nuts for a clevis lift, and if conduit nuts, where to find them and what size would I need? Also, I would imagine that the strut has to come completely off of the clevis to get the conduit nuts in there, correct?
Author:  tommudd [ Tue Sep 11, 2012 9:11 am ]
Post subject:  Re: Lift Modifications?
2 inch conduit nuts available at any hardware store
Don't need them since they are mainly to make sure you get both sides equal
3 of them per side is 3/8 of an inch
Yes you have to completely remove the clevis to install the conduit nuts if you want to go that route
Author:  Voyager [ Tue Sep 11, 2012 10:13 am ]
Post subject:  Re: Lift Modifications?
tommudd wrote:
2 inch conduit nuts available at any hardware store
Don't need them since they are mainly to make sure you get both sides equal
3 of them per side is 3/8 of an inch
Yes you have to completely remove the clevis to install the conduit nuts if you want to go that route


Thank you so much!
Author:  E2 [ Fri Sep 14, 2012 12:35 am ]
Post subject:  Re: Lift Modifications?
Good luck just get out there and have fun in your jeep.
Author:  Voyager [ Fri Sep 14, 2012 6:47 am ]
Post subject:  Re: Lift Modifications?
Did the clevis lift this past Wednesday. It'll be going for an alignment this Saturday, and then, possibly new tires.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/