i need to remove the rear sway bar in order to install my rear ome lift, front is done but not sure if i should remove the top links that connect it to the unibody or remove the clamps that connect it to the axle...

any tips???

Just disconnect the end links from the sway bar. There is a small hex on the end of the joint you'll need to hold with a wrench while turning the nut.

_________________
2010 KK 4WD BRILLIANT BLACK
Fox/King/Bilstein ATH BUMPERS ATH RACK GY DURATRACS

ATHFAB.com

I made the mistake of trying to remove the links from the frame rail and ended up shearing one of the rusty sensored word bolts in half

_________________
'08, OME HD/MD coils, Ironman shocks, Al's A-arms, Top plates, ATH front recovery, V-Tec Offroad wheels 17x8.5, Goodyear Wrangler DuraTrac's 265/65R17, Jasper Offroad 12" Dual LED lightbar, Mopar hitch and harness, RRO roof rails and cross bars, Viper throttle body, K&N FIPK, Hypertech Max Energy

We just removed the axle clamps and let it hang from the links.

_________________
2012 Liberty Latitude 4x4,3.7L,42RLE,MP1522,D30M/8.25"@3.73,215/85R-16 LTX A/T2,Bright White
1974 CJ5,258,T14a,D20,D30/D44@3.73,TransAm Red

thanks a lot guys