LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Strange looking weights in the front of the liberty?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=75818
Page 1 of 1

Author:  bettyhumpter [ Mon Jul 01, 2013 4:36 pm ]
Post subject:  Strange looking weights in the front of the liberty?

2011 Liberty Jet edition

I am trying to figure out why my liberty sits low on the drivers side front. I have a leaking shock on the drivers side rear, but that isnt the problem. I was underneath (legs sticking out of the front of the jeep and i looked up and to the left of the radiator and there are 2 steel weights mounted to the radiator core. Together they are the size of a can of spray paint. They are solid steel. What are they for? Should i remove them?

Any thoughts or suggestions

Author:  At The Helm [ Mon Jul 01, 2013 5:07 pm ]
Post subject:  Re: Strange looking weights in the front of the liberty?

I've always wondered too, but I don't have them on my sport.

Author:  crippled [ Mon Jul 01, 2013 9:48 pm ]
Post subject:  Re: Strange looking weights in the front of the liberty?

dryer or evap?

Author:  KKnut [ Wed Jul 03, 2013 10:15 am ]
Post subject:  Strange looking weights in the front of the liberty?

Ballast, so it passes the moose test! They tried making the bonnet heavier but no one could lift it. ;)

Author:  DREDnot [ Sun Jul 07, 2013 2:07 am ]
Post subject:  Re: Strange looking weights in the front of the liberty?

Those are harmonic vibration dampeners. Same as the one on the rear axle. You can remove them If you wish, but they are there to attenuate some sort of NVH issue.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/