So, the trio of lights came on just barely after hitting 100k on my '08 Liberty. Any diagnosis for this?
Also, just today, a few days after those lights came on, my speedometer and odometer stopped working and the brake light joined the club with the engine light following right after. Its almost like christmas on my dash. Thanks for any input.

Go to an auto parts store and see if they can get a Code # or #'s.
That will give us a better place to start.

_________________
07 KA Light Khaki, Manual trany.
2.5" Adjust-A-Strut JBA lift, Euro taillights,
Home made; Front Tilt Hood, Roof Rack, RAM Air, & CAI.
ESP Off Switch
Take a ride on the Trō side!

Sounds like an issue with the wheel speed sensors or ABS module. I had the ABS, BAS/ESP, and trac lights come on intermittently around 36k due to a bad wheel speed sensor. The speedo and odometer use the wheel speed sensors to get data, so if all of them fail or the ABS module fails, they will stop working too.

You can pull the DTCs/trouble codes by turning the key quickly between ON and ACC 3 times. The odometer will be replaced by dashes and any trouble codes should start to display (They'll look like P0300 or something like that). Write those down then post them here.

_________________
2008 Liberty Sport
OME Lift, JBA A-Arms + Track Bar
245/75/16 Nokian Rotiiva AT Plus
Numerous junkyard upgrades

I had the ABS, BAS/ESP & traction control light come on intermittently when I incorrectly replaced a faulty brake light switch. I misunderstood the directions and drove around for over a year with this annoy intermittent issue before I finally took it to my local auto parts store and pulled the code. Oddly enough a complete failure of the brake light switch causes a check engine light but incorrectly adjusting or partial failure of the brake light switch will give you an ABS fault.

_________________
08 KK OEM skid plates, JK winch bumper w/ Hella 500s, K&N filter, JKS front discos, black out headlights w/ fogs added, blacked out & euro mod tail lights, Curt Hitch w/ oem wiring, OME Springs, JBA UCA & top plates, Cabin Filter Retro Fit, Custom Fender Mounted Light Mounts w/ Hella 500s, ATH roof bars, rear flush mount LEDs

sounds like u gonna have to pull the dash bulbs or stop driving at night, lol. I have the trac control, abs and the esp on also,, my cruise doesn't work. does anyone know if that is disabling cruise?

_________________
06 Libby, maf unplugged, flowmaster , 201,000 mi and still rolling
06 Jetta TDI
4020 JD
2640 JD
02 Chevy 2500HD 8.1L 496
64 Chevelle project
Kubota diesel mower
5.9 Cummins

Yes

any suggestion on where to start? I have a bullydog monitor but for some reason it wont link and pull codes, I also tried switch on and off as some suggested to pull codes with no luck. I gotta get sum toys to work with if im gonna keep her.

_________________
06 Libby, maf unplugged, flowmaster , 201,000 mi and still rolling
06 Jetta TDI
4020 JD
2640 JD
02 Chevy 2500HD 8.1L 496
64 Chevelle project
Kubota diesel mower
5.9 Cummins

Gotta get the codes pulled 1st,90% of your el'cheapo code pullers will not pull ABS codes,you will need a higher end scanner(OEM scanner or something like the Solus Pro from Snap On).

I had a smarty programmer for my 06 ram and it read everything. im starting to see stuff is a little more complicated with this one.

_________________
06 Libby, maf unplugged, flowmaster , 201,000 mi and still rolling
06 Jetta TDI
4020 JD
2640 JD
02 Chevy 2500HD 8.1L 496
64 Chevelle project
Kubota diesel mower
5.9 Cummins

A lot of the time that sequence of lights come on it's a faulty brake light switch


Sent from my iPhone

_________________
Silver 2008 Jeep Liberty KK Sport
OME Springs / Bilstein Shocks / Clevis Lift / JBA Gen 5.5 UCA's
265/75/R16 Firestone Destination M/Ts / Pro-Comp Xtreme Rock Crawler Steel Wheels
ATH Steel Roof Rack Bars / RL Super Skink Rock Sliders
Hypertech Max Energy Engine Tuner