hello everybody its my first post in this community ,

its a great forum. sorry for my english is not good

im from Venezuela.

well, I would like a lift for my kk. 3 inch aprox

I only have two option.

TJM or OME.

I would like to buy this.

front: 2 spacer plate set,1/4 inch one per side, ome coil 2927 and shock ome 90009
back: 2 rear coil spring isolator, ome coil 2731 and shock ome 60069 or n132.

N132L is Not an option for me, because I can't buy in my country.

I try buy als upper arms.


What more I need, I will get 3 inch with this configuration ?

I Drive always in city. im not practice off road.

thanks, I appreciated your help.

Welcome to the forum.

To answer your question, yes you will get about 3" with that.

Up front you will want:
OME 927 springs
OME, Bilstein, or ironman front shocks
1/4" top spacer plates
Bumpstops
Al's a-arms(this will be needed at 3+")
If you want a little more height up front you can add a 3/8" Clevis lift

In the rear you will want:
OME 731 rear springs
2 extra rear spring isolators (put them on top)(if you do the 3/8" Clevis get 4 rear isos)
OME, bilstein, or ironman rear shocks
Bumpstops(we use hockey pucks)

I'm sorry I can't help much with the rear shocks. I don't know the lengths well enough. Tom might be better help.

Without the Clevis you'll be right around 3", possibly a little under. With the Clevis lift you'll be up at 3.5"

_________________
2011 Deep Cherry Red KK - Skyslider - JBA/Bilstein Adjust-A-Strut set at 3.5" - OME 731 Rear Springs - Bilstein Rear Shocks - Al's A-arms - 245/75-16 Duratracs - Rock Liazard Super Sliders

get 4" jba rear springs, better than ome springs with isos.
they work great woth ome long shocks.

i have ome front shocks with ome hd springs, top plate and 3 conduit spacers
rear ome long shocks with 4" jba springs.

didn't have to readjust my headlights.

send me a pm.. if you need help in spanish

Ok thanks.

The problem for me is I can't get other set up different a old man emu or tjm. Because I can't buy others brand in my country.

For this reason I need to set up the jeep with ome.

No more 3 inch lift.

Thanks

If you're keeping it at 3" then just 927s, your choice of front shocks, and a 1/4" spacer up front. JBA a-arms will help too. The rear 731s, your choice of shocks, and 1 extra isolator per side should keep you level. Don't forget bumpstops as well.

_________________
2011 Deep Cherry Red KK - Skyslider - JBA/Bilstein Adjust-A-Strut set at 3.5" - OME 731 Rear Springs - Bilstein Rear Shocks - Al's A-arms - 245/75-16 Duratracs - Rock Liazard Super Sliders

Ok thanks for everything, when I finish, I will post pictures.

Any advice it's good for me. Thanks

Hi again finally I bought my setup but I only bought ome kit ,

I going to install it tomorrow.

One question, if I install without cleivis and isos, my car stay in level ?

Thanks

yes

Any pictures with the lift yet!?

_________________
2011 Brilliant Black KK Sport - 3" OME/Bilstein & JBA UCA's, 245/75r16's & other goodies

Tomorrow