| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rocker Switch Placement http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=79597 |
Page 1 of 1 |
| Author: | Adam [ Sat Jul 12, 2014 9:31 am ] |
| Post subject: | Rocker Switch Placement |
So I am about to pull the trigger and buy some lights.  I'm going to start small with one switch for now, but will eventually need space for about three. Where did you put your switches or see other people put theirs? I like atthehelm's switch pod but don't have a need for that many, and I don't know if he actually ever started making them. I heard the wiring is easy to do up there and I could just fill the extra spots with blanks. So what are my other options? |
|
| Author: | Scar0 [ Sat Jul 12, 2014 10:06 am ] |
| Post subject: | Re: Rocker Switch Placement |
Cubby next to the steering wheel. 
|
|
| Author: | DetroitKK [ Thu Jul 17, 2014 3:19 pm ] |
| Post subject: | Re: Rocker Switch Placement |
I've been considering placing rocker switches at the bottom of the dash in the center. I don't have heated seats so IIRC there are at least 2 or 3 open spots down there around the hazard and back seat plug buttons. |
|
| Author: | Bmxer524 [ Thu Jul 17, 2014 9:51 pm ] |
| Post subject: | Re: Rocker Switch Placement |
DetroitKK wrote: I've been considering placing rocker switches at the bottom of the dash in the center. I don't have heated seats so IIRC there are at least 2 or 3 open spots down there around the hazard and back seat plug buttons. I don't think it's possible. The whole stack is a circuit board. I looked into it when wiring my first set of lights.  This is where I put my switch. Plans are to keep going across right under the switch stack DetroitKK is talking about. |
|
| Author: | lammarco [ Tue Jul 22, 2014 2:33 am ] |
| Post subject: | Re: Rocker Switch Placement |
I put my switches in the middle console 
|
|
| Author: | DetroitKK [ Sun Aug 03, 2014 5:22 pm ] |
| Post subject: | Re: Rocker Switch Placement |
Bmxer524 wrote: DetroitKK wrote: I've been considering placing rocker switches at the bottom of the dash in the center. I don't have heated seats so IIRC there are at least 2 or 3 open spots down there around the hazard and back seat plug buttons. I don't think it's possible. The whole stack is a circuit board. I looked into it when wiring my first set of lights. This is where I put my switch. Plans are to keep going across right under the switch stack DetroitKK is talking about. Good to know, I may end up dropping some switches in the same place as you instead. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|