| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| KJ Snorkel on KK http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=81281 |
Page 1 of 1 |
| Author: | NAMoulton1 [ Tue Feb 03, 2015 8:54 pm ] |
| Post subject: | KJ Snorkel on KK |
I know the KKs don't have a snorkel (except those Aussies...) but the KJ and KK seem similar so why haven't/can't we install one? |
|
| Author: | JeepMorrison [ Wed Feb 04, 2015 12:37 am ] |
| Post subject: | Re: KJ Snorkel on KK |
NAMoulton1 wrote: I know the KKs don't have a snorkel (except those Aussies...) but the KJ and KK seem similar so why haven't/can't we install one? Well then do it...... |
|
| Author: | CollinKK [ Wed Feb 04, 2015 8:14 am ] |
| Post subject: | Re: KJ Snorkel on KK |
The Commander has one too. That one might follow the sharper angles on the kk. Might take a combination from that and the kj snorkel? |
|
| Author: | Erikg84 [ Wed Feb 04, 2015 10:19 am ] |
| Post subject: | Re: KJ Snorkel on KK |
You could even try a DIY snorkel. I've seen some impressive PVC snorkels before. If you use just the right amount of heat, you can bend that stuff to match whatever contours you want. Just a thought. |
|
| Author: | Shaffer [ Wed Feb 04, 2015 11:28 am ] |
| Post subject: | Re: KJ Snorkel on KK |
in for pics if done. been curious as well |
|
| Author: | tommudd [ Wed Feb 04, 2015 12:13 pm ] |
| Post subject: | Re: KJ Snorkel on KK |
Check Pirate and other sites for homemade snorkels, haven't seen too many I would actually run on anything but a beater trail rig but ................ Here is one to get your creative juices going, even has " aftermarket " exhaust to get the tail pipe above the water as well 
|
|
| Author: | Erikg84 [ Wed Feb 04, 2015 12:44 pm ] |
| Post subject: | Re: KJ Snorkel on KK |
Wow... That's a hot mess! I was thinking something more like this. Doesn't look too terrible. 
|
|
| Author: | NAMoulton1 [ Wed Feb 04, 2015 9:08 pm ] |
| Post subject: | Re: KJ Snorkel on KK |
Just might do it 4x4kayak Erikg84 wrote: You could even try a DIY snorkel. I've seen some impressive PVC snorkels before. If you use just the right amount of heat, you can bend that stuff to match whatever contours you want. Just a thought. Thought about this too...but as Tom says and showed... |
|
| Author: | At The Helm [ Thu Feb 05, 2015 12:06 am ] |
| Post subject: | Re: KJ Snorkel on KK |
Here's one a guy from from Mexico (?) did. Looks like it might have been adapted from another vehicle. Doesn't have as much sass as the one in Tom's pic though   
|
|
| Author: | NAMoulton1 [ Thu Feb 05, 2015 8:36 am ] |
| Post subject: | Re: KJ Snorkel on KK |
That's an impressive bumper...really fat haha. Why have I never seen this KK yet? That's actually a really good looking snorkel too though haha. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|