Sorry to keep asking similar questions, I want to get this right, 1st time.
Regarding the conduit nuts; I'm pretty sure I know where they need to be fitted, I just want to be certain...
In the photo below I've used a red & green marker. I think the conduit nut should go underneath the lower spring isolator (15) so it sits between that & the clevis (12). Basically in the place where the red line is?
Am I also correct in assuming 2" conduit nuts are used as the shock OD is approx 2" & really the conduit nut is just there to act as a spacer to ensure both shocks are at the same height. If I made my own spacer with a 2" ID & an OD the same as the outer section as the shock would that be sufficient material without causing any other problems?
Thanks as ever!
