Over 150k miles like this.
Sent from my SM-N900P using Tapatalk
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| what is the measurement for the strut that fits into the cle http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=83857 |
Page 1 of 1 |
| Author: | Short Bus [ Fri Jan 15, 2016 4:23 pm ] |
| Post subject: | what is the measurement for the strut that fits into the cle |
Instead of doing a Clevis spacer stacking conduit nuts, i am going to just get some steel tubing and machine it to fit on my lathe. I can find the measurement of the conduit nuts, but am unsure if thats a good fit, or a bit loose. Does anyone know the outter dimension on the strut? Basically, I'm hoping i dont have to take a side apart, get the measurment, put it back together to get the steel and then tear it down again. Thanks. |
|
| Author: | JeepMorrison [ Fri Jan 15, 2016 4:25 pm ] |
| Post subject: | Re: what is the measurement for the strut that fits into the |
2.125". But honestly its just a measurement device. I just set the space with a socket extension, torque to spec, then pull out the extension. Sent from my SM-N900P using Tapatalk |
|
| Author: | JeepMorrison [ Fri Jan 15, 2016 4:27 pm ] |
| Post subject: | Re: what is the measurement for the strut that fits into the |
Over 150k miles like this. Sent from my SM-N900P using Tapatalk |
|
| Author: | tommudd [ Fri Jan 15, 2016 11:45 pm ] |
| Post subject: | Re: what is the measurement for the strut that fits into the |
Yep like Ricky Rocket stated you don't need anything, I use them simply to make sure that both sides are the exact same, plus I usually have a newbie helping so that way we are both on the same page |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|