| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| How do you set up an adjustable track bar? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=84847 |
Page 1 of 1 |
| Author: | ajohns1288 [ Sun Jun 26, 2016 12:13 pm ] |
| Post subject: | How do you set up an adjustable track bar? |
I just put on a JBA track bar. I pulled the old one off and set the jba to the same length eye to eye, then bounced my rear end a few times and put it on. After it was on, I turned it to lengthen until the axle looked centered. That's it right? I still have a bit of lean to the driver side, but I know that seems to be normal. |
|
| Author: | Scar0 [ Tue Jun 28, 2016 2:43 am ] |
| Post subject: | Re: How do you set up an adjustable track bar? |
Depends on the lift. Here is some info I found. viewtopic.php?f=88&t=74560&p=781539&#p781539 |
|
| Author: | tommudd [ Tue Jun 28, 2016 11:50 am ] |
| Post subject: | Re: How do you set up an adjustable track bar? |
ajohns1288 wrote: I just put on a JBA track bar. I pulled the old one off and set the jba to the same length eye to eye, then bounced my rear end a few times and put it on. After it was on, I turned it to lengthen until the axle looked centered. That's it right? I still have a bit of lean to the driver side, but I know that seems to be normal. When lifted it tends to pull the body over to the left so making the adjustable the same length as the stock gains nothing for you Remove it , and on level surface measure side to side etc to find a center area , then make the adjustable track bar fit that Little more to it but in short terms thats how you want to do it |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|