I just ordered my frankenlift from alljs and am shopping for wheels and tires to go with it. All the wheels I like are 16x8 with 4.5" back spacing. I really want to run the 265/75/16. I don't mind cutting the inner fenders and pinch welds. Jeep is a 2005 crd used for daily driving and some off road planning on ouray co and Moab trips in fall. I have seen a couple libs running pro comp wheels w the same specs but all are running 245/75/16. Will my tire wheel combo not work? Or what will it take to work. Thanks in advance

I doubt you will get that to work on a CRD. The driver side CV shaft is shorter than on a gasser making CV angles severe with enough lift to clear the 265 tires.

If you can figure it out with out blowing CV joints, all the power to you.

_________________
2006 Liberty CRD Limited

Provent @ 43,000 km
SEGR in progress
SAMCO Sport hoses @ 48500 km
Goodyear Wrangler Duratrac LT225/75R16

So no clevis lift and isolator? I thought it was ok as long as down travel was limited with a strap? So best bet is the 245/75/16 still trying to learn thanks

You should talk to TonyCRD.....

they will fit.. it will require a lot of trimming in the front bumper.. and pounding the crap outta the pinch welds. but they will clear.

_________________
2006 Renegade. Completely stock.

Do you have the clevis lift also or just plain franky lift?

He has a gasser so completely different animal than you have

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Oh got ya. Thank you all for the advice I will stick with the 245/75/16. Very excited should be here Friday.

I run a upper plate and 3 ring clevis on the front of my CRD...but the ARB bumper and Warn winch work as a limiting strap by weighting down the front so much
I am running a 245-75-16 and it works great.

_________________
06 Jeep Liberty CRD