I measured the tranny fluid temperatures to get a feel for pump flow performance before and after my Suncoast install this weekend. I have an aux tranny cooler installed already.
The inlet is the temperature from the tranny into the auxillary cooler.
The outletis the temperture from the auxillary cooler to the stock cooler on its way back to the tranny
See reults below (ambient air was 85 F, sunny dry weather);
Interesting;
1. the peak temp of 180 F is a bit high, dont you think?
2. The typical temperature difference of inlet to outlet is about 10F which seems low? Maybe the flow rate is low? This is the effectiveness of the auxillary cooler. The Stock cooler will be pulling it down some more