Weird: so I was adjusting my mirrors the other day and after about six seconds of the motor functioning, it just slowly stops working...almost like the motor has run out of battery power!

I wait for a minute, and adjust them for a few seconds and again, the motor kind of fades out.

This is with the engine running, BTW.

This happens on both sides, too--when one "runs out of juice" the other one is dead too. I have to let them sit for a minute to come back to life.

My thought was that the fuse is getting hot enough to create too much resistance to pass any current...but that's crazy, right?

_________________
2006 CRD w/99,300 miles
F31 from a previous life
EHM @ 42K, ProVent @ 79K
GDE Eco Tune & TCM @ 46K
Engine mounts replaced @ 55k/93k, Timing Belt @ 90k
Lift Pump @ 97k
OME Lift, 1.5''
Kenwood TM-V71 Ham Radio / Cobra C75WX CB
Surf Racks

My mirrors work intermittently too. I sometimes have to turn the ignition off, then back on. I'm the only one that dives it, so they don't get used much and I really haven't looked into iy.

DAve