Rear Axle

yakman4 · **Posted:** Thu Oct 22, 2015 6:59 pm

Did any 06 Liberty 4x4 CRD's come with the corp 8.25 or did they all come with the Dana.

olypopper · **Posted:** Thu Oct 22, 2015 7:08 pm

My 05 has a corporate............not sure if they changed in 06 or not.

JeepMorrison · **Joined:** Thu Jul 16, 2009 11:34 am **Posts:** 1236

yakman4 wrote:

Did any 06 Liberty 4x4 CRD's come with the corp 8.25 or did they all come with the Dana.

Actually both lol......8.25 in the rear, d30 in the front.

The d35 was in EARLY 2002.

Sent from my SM-N900P using Tapatalk

thermorex · **Posted:** Thu Oct 22, 2015 11:16 pm

As I know, for crd, 4x4kayak is correct, 8 and 1/4 rear and Dana 30 front.

mass-hole · **Posted:** Fri Oct 23, 2015 11:08 am

4x4kayak2112 wrote:

yakman4 wrote:

Did any 06 Liberty 4x4 CRD's come with the corp 8.25 or did they all come with the Dana.

Actually both lol......8.25 in the rear, d30 in the front.

The d35 was in EARLY 2002.

Sent from my SM-N900P using Tapatalk

Was the D35 in the front or rear?

JeepMorrison · **Joined:** Thu Jul 16, 2009 11:34 am **Posts:** 1236

mass-hole wrote:

4x4kayak2112 wrote:

yakman4 wrote:

Did any 06 Liberty 4x4 CRD's come with the corp 8.25 or did they all come with the Dana.

Actually both lol......8.25 in the rear, d30 in the front.

The d35 was in EARLY 2002.

Sent from my SM-N900P using Tapatalk

Was the D35 in the front or rear?

Real Early 2002 had a d35 in the rear, but honestly I have only seen three in my entire life.

But you have a CRD so no worries there

Sent from my SM-N900P using Tapatalk

yakman4 · **Posted:** Fri Oct 23, 2015 6:39 pm

Thanks for all the replies. I was trying to find axle shafts for the rear with the tone rings for the abs.
I ordered the set for the the 8 1/4 because I told these were correct.
So ended getting screwed out of the shipping. All I could find was OEM nobody makes aftermarket at rock auto for $255 each.

flash7210 · **Posted:** Fri Oct 23, 2015 7:14 pm

Just outta curiosity, why do you need new axle shafts?

yakman4 · **Posted:** Fri Oct 23, 2015 7:45 pm

My teenager lost control in the rain and wrecked went sideways up a 6 " curb busted the wheel and bent the axle shaft and caused 5K in body damage. But Jeep is still going.

flash7210 · **Posted:** Fri Oct 23, 2015 7:55 pm

Thanks.
I understand.
I was afraid that you somehow wore them out.

Local junkyard would have been the first place I would have looked.
Thats where my dad took me when I was a teenager.

jws84_02 · **Posted:** Fri Oct 23, 2015 11:05 pm

What parts do you all need. I'm parting one out and have plenty of parts available

thermorex · **Posted:** Fri Oct 23, 2015 11:19 pm

yakman4 wrote:

Thanks for all the replies. I was trying to find axle shafts for the rear with the tone rings for the abs.
I ordered the set for the the 8 1/4 because I told these were correct.
So ended getting screwed out of the shipping. All I could find was OEM nobody makes aftermarket at rock auto for $255 each.

Did you try randys ring and pinion? I think the site is ringpinion.com.

TwoBobsKJ · **Joined:** Fri May 11, 2012 8:03 pm **Posts:** 463

yakman4 wrote:

My teenager lost control in the rain and wrecked went sideways up a 6 " curb busted the wheel and bent the axle shaft and caused 5K in body damage. But Jeep is still going.

If you just need an axle shaft they are available at any AutoZone, NAPA, etc. I just bought one from NAPA for $169 that came with the bearing, seal and lugs. Axle replacement is actually pretty straightforward - longest part of the whole repair is pumping in new gear oil...

Bob

Rear Axle

Who is online