I don't recall a photo recap of the install, only some photos of the two boxes side by side and a comparison of the two air inputs and snorkels. Really nothing on the install itself.
Being visual myself I understand your pain and thought about phtographing the install but it turned out being so simple photos were not required. Here are the steps if it helps.
> I recalled that a couple of people damaged the lid a little by folding it bac so I pulled the whole air box lid off which was pretty easy to do, just loosen the output hose clamp and remove the plug to the MAF sensor...for some reason I really didn't need to do this part since that plug seems to unplug itself all the time.
> Remove the filter from the air box and set aside.
> Pull firmly straight up on the old box. It has three platic legs that sit firmly in rubber grommets in the fender.
> Pull out the short round tube that connected the air scoop in the front to the box.
> Once the old box is out make sure the rubber grommets are still in place and the snorkel is attached to the box.
> Push new box firmly back in place (this is the hardest part of the job and a little soap or lubricant on the grommets might help.).
> Replace the filter, the box cover, reconnect the cover to the outlet hose, and oh don't forget to plug the MAF back in.
> Finally bolt or rivet the little air deflector on the cross piece just in front of the snorkel.