CV Boot Adjustment with Frankenlift

Wasatch15 · **Joined:** Wed Jul 13, 2005 7:52 am **Posts:** 242

Have those of you that have the Frankenlift installed on your Libby adjusted the CV boots out further so the bellows aren't touching, all squished up against each other? If so, after adjustment, does the boot stay where you placed it even though there isn't a groove machined in the CV halfshaft where it is now installed?

Thanks,
Ron

JJsTJ · **Posted:** Thu Jul 13, 2006 10:02 am

I have about 25K miles (on my 03) on my Frankenlift w/out moving the boots and no problems w/ them. We will see how it works out on my 04 since swapping the FL to it.

Se7enLC · **Posted:** Thu Jul 13, 2006 11:37 am

I had a CV boot replaced after the lift was installed, and it definitely looked a lot better than before, now that all the bellows aren't squished. I considered having them re-do the other side, too, but seeing as the factory clamp is welded, they'd probably have to just replace the whole thing anyway, I may as well wait until it fails.

fdezone · **Posted:** Sat Jul 15, 2006 11:36 am

My passenger side CV boot high-ordered.

Jeepjeepster · **Posted:** Sat Jul 15, 2006 12:16 pm

fdezone wrote:

My passenser side CV boot high ordered.

I said that really slow and it still makes no sense to me. :?:

fdezone · **Posted:** Sat Jul 15, 2006 4:51 pm

It high-ordered, aka, high-order detonation, blew up, disintegrated, etc. Or, I tore my CV boot!

JFortier777 · **Posted:** Sun Jul 23, 2006 2:42 am

fdezone wrote:

It high-ordered, aka, high-order detonation, blew up, disintegrated, etc. Or, I tore my CV boot!

AH! The horror!

CV Boot Adjustment with Frankenlift

Who is online