EVIC install problem

Ripple · **Posted:** Sat Jan 13, 2007 2:42 pm

I wired up a used/ebay EVIC in my '06 sport CRD and it doesn't turn on. I checked the B+, ingtion +, and groud and all seem to be OK.

what can I check next? how can you tell if you have a bad EVIC?

unixxx · **Posted:** Sat Jan 13, 2007 8:52 pm

You can try wiring the Ignition sense line to the B+ line. If the console then works, you've had the wrong ignition output wire.

Ripple · **Posted:** Sat Jan 13, 2007 9:36 pm

so if I just put 12V to pin 3 and 4 (BAt + and Gnd) it should turn on and at least light up?

Ripple · **Posted:** Sun Jan 14, 2007 3:29 pm

put +12 on pin 3 and pin 5 with ground on pin 4, and it was DOA. darn.

unixxx · **Posted:** Sun Jan 14, 2007 5:46 pm

If it doesn't come up with Ignition+ and B+ tied to battery positive and B- tied to battery negative, then it's probably toast. It should at least say something like "Bus Error" when you do this. Can you send it back?

EVIC install problem

Who is online