My sunroof doesnt seem to want to vent or move back, when I press a button I hear the motor run but it doesnt move, it almost acts like it jams or something, any ideas? Here is a pic for reference:



































Sorry, I crack myself up, I hope I got someone with that joke............seriously though, if your interested heres the original thread:
http://www.lostjeeps.com/forum/phpBB3/vie ... hp?t=19393

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

You GOTTA take it in for the ball joint recall. Tell the stealership you think the sunroof has a defect too!

_________________
05 Limited

Ya, thats a good idea, my windshield has also developed some odd cracks that I want them to look at. Thanks.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Don't forget the Driver's side roof rack rail that mysteriously disappeared

_________________
2006 Jeep Liberty 65th Edition, 4x4, Auto
Mopar Borla Single Side Exhaust
Mopar Full Skids and Tow Hooks

1991 Pontiac Firebird, 305TBI w/ 5 spd manual, Black w/ T-Tops, Pretty much all stock

Im guessing that they will say "owner neglect" on that one.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Judging from the picture, all that is wrong is that it is out of adjustment. There are 2 screws on the inside on each side. I don't remeber exactly what size they are by they are Torx and on the smaller side. The easiest way to check is to put your hand on the sunroof window and see if you can lift the rear right. If you can then the screw has simply loosed. They do have loctite on them but their toqrue is set at approx 2-4 NM at the factory. They might loosen.

If you can't move it, then locate the appropriate torx driver and loosen the screw slighltly so as not to remove is from it's channel. Raise that section of the glass a little and retighten it. You migh have to do it several times to get it perfect. The idea is to have the rear just slighyly higher than the front. An easy trick to do, is loosen and glass open door, and put fingers on sunroof just to make sure it's flush (or have someone help you). Push up slightly and secure. For a perfect sunroof aligment I start out with the front and work back. It doesn't matter what side you start on or even if it's only one side to do and the other is fine.

Just remember, hand tight torque. DO NOT STRIP THE SCREWS!

Hope that helps, but from the picture there is only so much we can do and it seems like the motor is working.

Then next step, could be the glass seal torn.......

_________________
2006 Liberty Renegade
Daystar 1.5, 2.5 Lift
Mickey Thompson MTX 225/75 16
Surco Roof Rack
Surco Spare Tire Bike Rack
Garmin Map 76 GPS

Hmm, Ill have to remember this when I actually get to replacing the roof panel and reinstall the sun roof.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Just had a look at all the damage pictures. It's not too bad.

_________________
2006 Liberty Renegade
Daystar 1.5, 2.5 Lift
Mickey Thompson MTX 225/75 16
Surco Roof Rack
Surco Spare Tire Bike Rack
Garmin Map 76 GPS