Has anyone heard anything good or bad about these A-arms from RRO? They say that they are a factory jeep part and not aftermarket?So i guess that means they don't come with moogs. Iam just trying to do research for my options when i do decide to change my upper A arms. You guys probaly recommend jeepinbyal which i will probably end up going with due to the proven quality, But RRO's A-arms are $89.00 a piece which is alot cheper then al's(389 per set), but i guess it could be the same as most things and you get what you pay for?What do you guys think?
Thanks

Josh

_________________
**REMEMBER YOU CAN ALWAYS GET A HUMMER IN A JEEP.... YOU CAN'T GET A JEEP IN A HUMMER**
2003 Jeep Liberty(KJ) Renegade,235/75/16 Goodyear Wrangler Silent Armors 245/75/16 MTR's,Factory Skids, Selec-Trac,trac lock,Husky Floor Liners,OME Lift,948 rear/926 front,Rusty's strut plate,clevis 2.5 "s, Al's UCA's Gen 4.5.

Well if they say they are OEM a-arms then they are no better than the one's you have on your KJ already,they will be the exact same thing as you already got.Al's a-arms are better for the fact you can get a lifted KJ back into alignment and they have replaceable/greaseable balljoints,hence the extra cost.

They are the factory arms. I hear RRO has the worst cust. service. Someoneon here or at kj country bought those arms and RRO never shipped them out but he was charged for them. Get al's they're 100x better.

_________________
02' Sport- SOLD

07' Dodge Ram Quad Cab 1500 4x4
Yeah it's got a hemi!

myjeepwalks
I have had problems with them in the past as well and told myself i would never buy anything form them again,even the stuff they say on their website about other lifts wearig out balljoints..haha

tjkj
.maybe they are jsut stock KJ a-arms...........i am starting to think this is a joke!!

_________________
**REMEMBER YOU CAN ALWAYS GET A HUMMER IN A JEEP.... YOU CAN'T GET A JEEP IN A HUMMER**
2003 Jeep Liberty(KJ) Renegade,235/75/16 Goodyear Wrangler Silent Armors 245/75/16 MTR's,Factory Skids, Selec-Trac,trac lock,Husky Floor Liners,OME Lift,948 rear/926 front,Rusty's strut plate,clevis 2.5 "s, Al's UCA's Gen 4.5.

That was me, and I'm still waiting for that money. By the way, don't order UCA's from them. Yeah, those arms may be half the price of the dealership but, it does you no good when they have your money and you have nothing.

_________________
Ron


"There are few problems in life the liberal application of duct tape can't solve."

FYI, the moogs are LBJ (lower ball joint) & what UR considering is the upper arms. As already mentioned, Al's uppers have a greasable/replaceable ball joint that is better than the OEM. Switching to the Moog LBJ's is highly recommended when you lift the vehicle. i ordered my Moogs 2 days after installing the Frankenlift. My passenger LBJ (stock) failed the day B4 the Moogs arrived in the mail and i incurred some damage to the vehicle due to the failure.

Hope i haven't muddied the waters.

_________________
'04 Renny
Mod's: See Avatar
Conquests: Poughkeepsie Gulch, Governor's Basin, Black Bear/Imogene/Engineer/Cinnamon pass, Coal Creek OHV, Badlands OHV, S.M.O.R.R., K-Rocks, Parent's driveway

Al uses Moogs in his upper arms.

I bought a used stock upper arm from Mutt for a spare. I took the boot off to clean it out and put more grease in it and the old grease was gray, he said it only had 18k on it too.

Ive tried to get the boots off my arms thats already on the Jeep and I cannot. Ive gotten the rings off but Im worried that Im going to tear a boot so I just put the rings back on.

I believe the whole problem is the fact that water gets inside the boots. If there was an easier way to grease them then I believe they would be fine.

Found a pic..

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster

I installed a 3 ring clevis lift today and now at full drop i have UBJ contact so Al's upper A-arm's are a must. They only reason iam looking to see if anyone else makes the A-arms is due to the duty fees and shipping to get these things to northern canada($$$).Let me know if anyone wants to sell their's.

_________________
**REMEMBER YOU CAN ALWAYS GET A HUMMER IN A JEEP.... YOU CAN'T GET A JEEP IN A HUMMER**
2003 Jeep Liberty(KJ) Renegade,235/75/16 Goodyear Wrangler Silent Armors 245/75/16 MTR's,Factory Skids, Selec-Trac,trac lock,Husky Floor Liners,OME Lift,948 rear/926 front,Rusty's strut plate,clevis 2.5 "s, Al's UCA's Gen 4.5.