In my attempts to get the EGR out, I unbolted this plastic thing in an attempt to get the hoses out of the way. We'll, as I pushed it aside,I heard a snap and the little hose on top was no longer connected.

I am not sure what the hoses are for and I was hoping I could glue it back on and if not, I could go to an autoparts store and buy a new one tomorrow.
You can see the braided hose that broke off sitting on the lower left corner. This thing was bolted just above the EGR valve.

Please help ASAP

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

The black thing that you broke is the fuel return block. The return pipe from on top of the injectors, the return from the end of the rail, etc. all join in this manifold and then go back to the tank. You'll need to get a new one from the dealer.

Thanks.


How the heck do you remove it?

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

The one hose seems to be one with the block and it runs somewhere behind the alternator. I can't get the one hose off the block.



Also try as I might, I cant get the hoses off the EGR

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

There have been three dudes trying to remove these EGR hoses with no luck.


Took the clamps off and pull and no luck

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

Ended up repairing it with epoxy.

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

Two 3/8" brass Ts, three 3/8" barbed X 3/8" NPT fittings, one brass close nipple, and one 7/16" barbed X 3/8" NPT fitting, and four worm gear clamps. Take the Haysoose Spring loaded Clamps and donate them to Al-Queita.

You will be ready to go.

_________________
2006 Pearl Green CRD
Magnaflow 2 1/2" Cat Back
KJ Extra Leg Room Brackets, Carter Lift Pump, V6 Airbox, ORM
Fuel cooler, Oil Separator, Progard 7
Gauges EGT Boost Trans Temp Oil Pres, Michelin LXT AT2 245 70 R16
7,000# Draw Tight hitch, PML EX Deep Trans Pan
Centrifuge, SunCoast, Transgo, RAM TCM, InMotion Stage 2
Wife's 99 TDI VW Beetle