scoobysnax wrote:
Some people put lifts on their jeeps and we all know that increases the chance to roll and changes the bumper height, but (hopefully) they account for that when they drive. Other people add over 1,000 lbs in armor to their jeep and I’m sure their stopping distances are longer than stock, but (hopefully) they too adjust their driving for that. Some people pull large trailers, the list could go on and on. I’m just asking a simple question. “Can you change the psi setting on the EVIC” which was set up for the stock tires. I’m not even trying to disable the seat belt alarm. What about the people running an E rating tire with a max psi of 85?
The max psi for my tire is 44 psi (cold.) At 40 psi (cold) I doubt I am coming close to the max pressure for failure. My tire (firestone destination AT) is a size larger over stock (245/70/16) and therefore has a larger contact patch than the stock tire did (235/70/16.) So, logic would suggest that while a slightly over inflated 245 would have a reduced contact patch it’s probably similar to the contact patch of the stock 235. So unless you’re saying 40 psi is dangerous in and of itself because it might blow up I think it’ll be fine.
As a side note I have reduced the psi to 37 because the ride is a little less harsh than it was at 40.
I would also like to know if the max tire pressure settings can be modified. I was running about 43-44 psi but dropped to 39-40 after adding the EVIC. There must be some help for those running E rated tires. I have always run tires at near the max pressure because they seem to wear more evenly, but I only have about a million miles to base that on.
Lewis
Lewis