I've done alot of research here and from what I understand when putting in HD OME springs and Ranchos all around I need to replace the bumpstops as well(I think Tom mentioned it a few times ). Anything else I should be doing? I'm replacing stock...I don't think uca is necessary right, unless I go higher?

Also, are there any how-to instructions here on how to do it all? I know about how dangerous the springs can be when replacing them....
Thanks again guys.

_________________
2008 KK GREEN
OME HD springs and shocks all around
LT245/75R16 Goodyear Duratracs
Aries 1051 black grille guard

All the directions are the same as the Frankenlift install article here:
http://www.boulderbars.com/images/kj_pr ... rticle.pdf

The only additional thing you'll need is a strut compressor for the springs.

_________________
- Mike
'12 JK

Jeep Tech Files

thanks or the link. going to be doing a complet OME swap in the near future too! I think I will have a local shop rebuild the fronts for me though.

_________________
Jason
----------

Thanks Mike, much appreciated

_________________
2008 KK GREEN
OME HD springs and shocks all around
LT245/75R16 Goodyear Duratracs
Aries 1051 black grille guard

sounds like you've just about got it covered, just read up on all of the lift installs from here and jeepkj they will help you out a lot!

and don't be afraid to ask questions while you are installing it, I had too

_________________
1980 Jeep CJ7 Buggy
SOA, D44/ FF14B, SBC 350, SM465, NP205, 108" WB, 37" MTs

http://www.dpgoffroad.com/
http://www.ucora.org/
http://www.christianoffroad.com/
http://jeepinbyal.com/