Hi, I searched here and either found WAY too many posts to shift through or none at all. After getting the front end stuck in some deep mud a few times, my passenger front fender flair is hanging a bit low in back. The clips that hold it to the outside of the fender have been sheared. Luckily, there are still a few attached in front and the inner wheel well cover holding it on. Any idea where I can get some new clips online to reattach my fender flair?
Thanks,
Jonathan

_________________
2004 liberty sport, 2 1/2" Frankenlift. 245/75r16 Rubicon rims & tires, more to come!
--
Suzuki Samurai rock-crawler buggy. Ford 2.3L turbo motor, Toyota solid F/R axles, custom 3-link in front, 4-link in rear, King 14" travel coil over shocks all 4 corners, 6:1 low range t-case gears, full cage, Prelude seats, etc, etc...

do you have some pics of the clips you need? I have some spare clips in my garage that you can have

_________________
1980 Jeep CJ7 Buggy
SOA, D44/ FF14B, SBC 350, SM465, NP205, 108" WB, 37" MTs

http://www.dpgoffroad.com/
http://www.ucora.org/
http://www.christianoffroad.com/
http://jeepinbyal.com/

the only place i could find them were at a dealership...

_________________
02 Jeep TJ Sahara, 33's locked up front
03 SAS KJ 0n 35ish boggers(Sold )
Petersens 4wheel: http://www.4wheeloffroad.com/featuredve ... index.html

I bought a box of 25 last summer......
http://www.clipsandfasteners.com/Produc ... 0&CartID=1

_________________
2008 KK GREEN
OME HD springs and shocks all around
LT245/75R16 Goodyear Duratracs
Aries 1051 black grille guard

on a website I moderate I have a thread pinned at the top where people put in links on where to find certain parts like these clips... maybe it would be a good idea to do that here too....just a thought
something like this
http://bbcboards.zeroforum.com/zerothread/36063

_________________
2008 KK GREEN
OME HD springs and shocks all around
LT245/75R16 Goodyear Duratracs
Aries 1051 black grille guard

Are you talking about the plastic push pins?

I cracked the inside of my wheel well last year, and when I ordered a new one, I stripped out almost all the pins. Just go to PepBoys or AutoZone, and they always have them. They are like $1.99 a piece or something, but its a lot easier than having to order them.

They are usually just on a spinning rack somewhere in the store.

_________________
2004 KJ Sport 4x4 Black
245/70/16 Grabber AT2's
2.5" Daystar Spacer Lift w/ Ranchos
Mopar Skids
Hi-Lift
http://www.cardomain.com/ride/3202356