ROKTAXI wrote:
Sir Sam wrote:
ROKTAXI wrote:
Owning many XJ's, one CRD, and swapping a CRD into an MJ (with a CRD planned for my XJ). I can tell you right now its going to take LOTS of work to get a KJ to the point that your XJ is at. .
Thanks all for your input. I knew it would be a huge sacrifice to go with a stock KJ but I was hoping for mods that wouldn't break the bank.
Sir Sam: Your recommendation of swapping a CRD into the XJ may be the compromise. I'll have to research what's entailed for that swap. I've budgeted $2500 for a stroker and now I will weigh that against a CRD swap. As a side note, I have a '06 TDI and have been super impressed with the performance. That swap, however, is not financially feasible or maybe not at all as I have not found anyone who has accomplished it. The CRD may be a doable swap as my main goal is added power for towing as well as fuel mileage. The one major down side for me is the electrical. Do you know of any write-ups on the CRD swap?
2500 is a little on the low side for buying a wrecked CRD. It's more likely going to cost 3-3.5k for a wrecked CRD. I paid $3400 for my rolled CRD Limited(which various parts are being picked off of it and sold, and the leather interior went into my sport).
Wiring, ya, its wiring, and plenty of it, I've spent plenty of time with the service manual sitting down and figuring it out. The short of it is, keep KJ drivetrain wiring intact, interface to XJ wiring where needed(run-start signal, etc).
The trickier things are things like the guage cluster, I haven't gotten this far yet but right now the plan is to use a TJ gauge cluster, it uses the PCI bus - like the KJ does, so hopefully all the things like engine temp, rpm, voltage, etc will work off of that cluster.
It's not uncomplicated, but sitting down and tracing out the connector pinouts is the way to go. basically there are about 4 connectors that interface the drivetrain harness with the KJ harness, do the work to connect these up together and you have most of the ancillary controls setup(AC relays, etc).
Best I can say is watch my thread as I am posting all the information that I can as I come across it there:
viewtopic.php?f=5&t=32756
_________________
http://www.Colorado4Wheel.com
"Its not about what you can
DO with your Jeep, its about where you can
GO with your Jeep."
Knowledgeable - But Caustic