I was looking into buying a new set of wheels & tires for my ride, next summer... I came upon this in an ad:



They are 31-10.50-15 tires on what seems to be actual Jeep rims (Wrangler?). They do look nice but I'm worried the rims would actually rub on the calipers (mine being a Libby). Anyone who already tried to install something similar?

Thx!

_________________
RIP 10/31/2012
Green Metallic 2006 CRD Limited
GDE Hot tune ~ Pre-F37 TCM ~ Transgo shift kit ~ MagnaFlow ~ Homemade Provent ~ OME 2" lift & Airlift ~ Samco ~ Euro TC ~ Lift pump ~ Nylon fan blade & Hayden clutch ~ Etc!

Its been said that aluminum wheels are too thick to clear the calipers. I run steel 15s, and I couldnt imagine any thicker constructed wheel fitting over the caliper. The steel 15s clear the caliper by less than 1/4". I highly highly doubt the aluminum wheels would be a worthwhile buy.

_________________
2006 Black KJ Sport
31x1050r15 Nokian Vatiiva M/Ts
15x7 Cragar soft 8s
Skid Row engine skid
Skid Row gas tank skid
Hella 500s

you can run them but have to use spacers to fit over the brakes
so after buying the wheels,
spending 200 bucks on good spacers ( Spidertrax)
so the question is why not just buy wheels that fit

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Point taken! Thanks, guys!

_________________
RIP 10/31/2012
Green Metallic 2006 CRD Limited
GDE Hot tune ~ Pre-F37 TCM ~ Transgo shift kit ~ MagnaFlow ~ Homemade Provent ~ OME 2" lift & Airlift ~ Samco ~ Euro TC ~ Lift pump ~ Nylon fan blade & Hayden clutch ~ Etc!