Transmission Shifting

Houghton · **Posted:** Tue Apr 26, 2011 12:15 pm

Hello I am new to this I hope I am doing this right. I have a 2005 CRD limited with 65000 miles on it, all stock. About a week ago it started shifting from 2 to 3 hard like it would throw you through the windsheld. It only does it when shifting up, but when i turn the overdrive off it won't do it. Could it be my torque converter? Any suggetions?

Thanks James

Joe Romas · **Posted:** Tue Apr 26, 2011 12:42 pm

Read the noob guide and look for the link where you can download the FSM (that stands for Factory Service Manual).

With that go to the CRD TECH section and look for the thread on doing a "Quick Learn" and look at the pages in the FSM I have listed. DON'T POST IN THAT SECTION :frankie:

Then find the procedure that covers the second to third upshift :BANANA:

Your TCM (transmission control module) is intelegent or maybe just dumb, anyway it needs to "learn" :JEEPIN:

Houghton · **Posted:** Thu Apr 28, 2011 11:47 am

Hey Joe thanks for the help! I found what you where talking about in the manual, but it is real confusing. Do I need a scan tool to do this or can I just disconect the battery?

Thanks James

Joe Romas · **Posted:** Thu Apr 28, 2011 4:00 pm

Houghton wrote:

Hey Joe thanks for the help! I found what you where talking about in the manual, but it is real confusing. Do I need a scan tool to do this or can I just disconect the battery?

Thanks James

James.
Here's the thread and flman replied with instructions. No scantool is needed.
viewtopic.php?f=98&t=49854

Houghton · **Posted:** Wed May 04, 2011 12:50 pm

Thanks again Joe,

I tried the Quick Learn, and it didn't help. Any other suggestions? Looks like i might have to take it to the stealership!

papaindigo · **Posted:** Wed May 04, 2011 3:03 pm

You did check fluid level? Pretty obvious but since it's not mentioned I feel compelled to ask.

Houghton · **Posted:** Wed May 04, 2011 3:39 pm

I did, and I was hoping it was that simple, but my luck its not.

Thanks

Rabert · **Posted:** Wed May 04, 2011 4:34 pm

Checkout this thread. I had a similar issue after doing the ORM and FLCV. I could clear the codes but it would creep back up. I "backed out" the FLCV mod and ORM. took TCM and ECM connectors off/cleaned/inspected/installed, covered bare wires by EGR with split heater hose and viagra I was up and running, the jeep that is....anyway I've got the ORM mod back in place, keeping my fingers crossed.

viewtopic.php?f=5&t=59945

Transmission Shifting

Who is online