Anyone had to replace the left rear axle seal and bearing yet? Mine started leaking this week after changing diff. fluid a few weeks ago...

_________________
2006 Liberty Sport CRD
GDE FT ECO/HOT Tunes.
OME 2.5
265 70r 16
SC Bumper
Glass Pack
Provent
Dodge 2500 in tank Lift pump
Samco Hoses
Rocky Road UCA
Transgo shift kit
Updated torque converter
Weeks Kit 1 & 2

Huh, I'd nearly forgotten that I had one replaced by the dealer at about 5K miles.

_________________
Manure green 2005 CRD sport4x4, GDE Hot tune, Cat Gut, OE skids, Draw tight hitch, Duramax lift pump, 160K on multiple varieties of fuel, XM radio, Escort live with Redline, fog light mod, GPS, Icom IC7000 all band radio call sign KC9QPF, Grabber AT2s on Soft 8s, FIA grill blanket.

While off road i somehow managed to damage the backing plate for the rear right wheel end.

In order to replace the backing plate one must remove the axle shaft.
I had ordered the incorrect seal and completed the job without replacing said seal.

I found myself replacing the seal 2 years later. It was leaking slightly.

_________________
06 CRD Limited. IMII, GDE TCM, Carter transfer pump, Upgraded oem primary, 2 micron secondary, 3 inch mandrel straight pipe.
Transgo shift kit, EHM, fcv butterfly removed, egr plated off. 19 3/8 solid flex fan, no electric fan, 10k lb aux trans cooler.
Frankenlift II, Mopar skids, allj's rails, 235/85 km2 on stock rims

They aren't that bad to get out but putting them back in is a little fun though.

_________________
My CRD Build Thread
Soon to Come:more lights