I just got a LBJ from Napa and it has a grease fitting on top. Is there enough room between the top of the BJ and the bottom of the CV to fit this? Or did I get the wrong LBJ.

If its right on top no there won't be enough room to grease it

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

It is right on top. Is this the wrong BJ?

I wondered about this too. If one were to change the fitting to a 90 degree zerk would you be able to grease it?

_________________
2005 Red KJ CRD, TOTALED 12-21-11

2005 Blue KJ Sport CRD, GDE, Magnaflow muffler, Destination AT, Amsoil filters, Fumoto, Timing belt and waterpump @ 99,600, 11 blade nylon fan, 2905 hayden fan clutch, EURO TC




Arguing about whether the glass is half full or half empty misses the point: the bartender cheated you.
Unknown

No room for a 90 degree fitting.

And no it's not the wrong LBJ just bad placement of the grease zerk.The MOOG K3199 LBJ's is what you want with the zerk on the side of the LBJ.