I just changed the oil in the Jeep (can't wait to get the UOA back on it) and I switched to the Mobil1 M1-301 oil filter for more oil volume. It screwed right on. I added an even 7qts of 5w-40 TDT oil instead of the 6.4qts. After checking the oil on the dipstick.....it definately was higher on the dipstick than with a stock filter with 6.4qts. Usually the oil came up to and just covered the "M" on "Min". Now with the oversize filter and the 7qts it is about 1/8" below the max line which I thought would be a bit too high. Is that level ok or should I drain a bit out?

Thanks, Jim

_________________
Stock 06 CRD Limited
Timing belt replaced at 110,000 miles

That's fine, I wouldn't worry about it.

_________________
05CRD: GDE Hot ECU & TCM tunes, Provent, Cat filter, Facet lift pump, TransGo kit, Florida TC, Samcos, stainless brake lines, HDS thermostat, Renegade light bar,
RL super sliders, Bilstein adjustables, Al's Gen 4.5 Arms, 235/85-16 Duratracs, DTT rear, Elocker front, EVIC+TPMS, Turbo timer, McNally pillar gauges, Weeks Stage II kit.

M1-301 with 7qts works.

_________________
2006 Liberty Limited CRD, Deep Beryl Green, Yeti tune, Arp studs, new cams, rockers, lifters, TB. "Green Monster"
2005 Liberty Sport CRD, Deep Beryl Green, GDE Hot Tune, ARP studs. "Rocket"
1982 Fiat 124 Spider Convertible. "Fiona"