Guy's, I know of a set of black 15" steel wheels off a TJ going for a good price, but not sure about:

A. will the bolt pattern match ?

B. if so, they are only 4" backspace, so will they foul the front arch when steering to full lock with 30" tyre's ?

I realise they will stick out in the region of 2" more, but I have a small lift (40mm at front) and think that might be ok for my use of the truck ..

What d'ya reakon ?

_________________
05, 2.8 CRD Sport (6 speed manual)

If stock TJ wheels they will not fit but it sounds like they are aftermarket with the backspacing
Bolt pattern is the same
what width are they that can be a deal breaker as well
if 7 inch you'll be fine
maybe some light rubbing but with lift should be a go

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Cheers Tomm

Ok, so the bolt pattern is the same, but they are 15" x 8" !!! will this be a prob with 30x9.5x15's on ?

_________________
05, 2.8 CRD Sport (6 speed manual)

You could run them but that is wide for that size, plus you could have more rubbing due to width

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Ok cheers mate ... seems they may be a little bit more of a gamble than I can afford whether they work or not ... might have to give them a swurve

_________________
05, 2.8 CRD Sport (6 speed manual)